722.6/Nag1 Rebuild Part 1, Clutch Drums

722.6/Nag1 Rebuild video in 4 Parts, Part 1 we are rebuilding the clutch drums, I did forget to mention clutch clearances, i will look that up and post for next week. Next week we will sub assemble the trans, pump, and air check.

[@imt5802]

Absolutely insightful! Can't wait to see the next part in this series. There is always something I can learn from you, Gary! Thank you so much

[@JOMaMa..]

Thanks for sharing your knowledge and experience

[@d2doctor]

Very cool to see one going back together 😊 I'm looking forward to part 2 👍

[@kevinikola8003]

Thank you Gary. It is nice seeing a build up for a change.

[@cuthburtyes9529]

Thank you Gary for your knowledge sharing keep up the good work sir.

[@frankwrenchman4573]

Gary thanks again just don't give up on us we will watch and learn😊

[@GaryFerraro]

Thanks Frank, still here. Shop is very busy last few months working 7 days to keep up

[@rtz549]

I like that tripod on that press.

[@kasems1536]

Thank you so much. From Bangkok,,,,

[@GaryFerraro]

Welcome, Greetings from New York

[@skutahuniai4830]

Look forward to your videos for my Sunday morning coffee. Excellent content Gary but too much light. Hard to see the details on the drums that you are pointing out.

[@LeonardoCostaUSA]

Super cool !!

[@carlosguillen2816]

Thanks Gary

[@lukestrasser]

Great video as always Gary! I bet you use a lot of trans gel! Do you use the green at all or mostly the blue?

[@GaryFerraro]

mostly blue

[@iliketorockrock]

Thank you for Sharing !

[@rtz549]

That case is really clean. What do you use in your heated parts washer?

[@GaryFerraro]

I purchase a degreaser soap, comes in powder form

[@Mels-Garage]

On minute 33:00 i put my dish up. I just noticed because I was watching your video, should I disassemble and put dish face down?

[@GaryFerraro]

yes faces down

[@Mels-Garage]

@@GaryFerraro I've been watching all of your assembly videos and I must have missed this one I did indeed put it face up ☠️

[@Mels-Garage]

@@GaryFerraro I am at a loss, just finished putting everything back together, i got a steady stream of fluid between the converter and pump, it just dumps all the fluid if left to idle, has new pump oring, new main seal, new bushing, any idea what can cause this?

[@MrMsD77]

Otimo video complimenti 👏👏👍

[@noobkilla-m9i]

I wonder if this is the part responsible for no reverse in my 2001 toyota rav 4

[@GaryFerraro]

No, No reverse you have a bad geartrain, U140 Trans

[@noobkilla-m9i]

Yes U140@@GaryFerraro

[@richmansvideo]

where to buy kit?

[@zacharygalliher609]

Where can I buy a replacement b1 roller/needle bearing

[@GaryFerraro]

can you send me a picture?
[e-mail]

[@PanovArtem45]

👍

[@rtz549]

Clutch material doesn't need to be soaked anymore?

[@anitaswier4906]

"promosm" 🙄