Ok thank you so much for this video!! I plan to put solar on my 40’ Open Range but I currently have an onboard generator, and I even have an inverter to power the residential fridge while I’m driving, but I’ll need to purchase a larger inverter to power the rest of the rv. I figured there was a way to work around buying all sorts of expensive devices and switches. But I haven’t found a video that explains it like you do. New subscriber!!
I just ran a 12gag extension from the inverter to the rear of the RV and plugged it like normal with the conversion adapter. Yes I still need to shut off the bigger draws Ac, Fire place and the microwave. But it works like a charm thanks for the video
On your next gen setup, maybe try finding an inverter with an A/C input, then drive that with a Genset. No transfer switch necessary, and also you can save quite a bit of fuel in the Genset. The A/C input would drive the loads for the camper and also charge your batteries at the same time. Happy Camping !
Anytime you fish wire when you pull your new wire go ahead and pull a PC of paracord or small line with it. That way if you ever need to pull for anything else you already have a feeder line in place.
I'm in the same boat trying to figure things out I'm adding a complete solar system to my slide in truck camper. And I was wondering how to use the RVs existing system I was wondering if I could any field system in place which had an AGM battery. And then add solar with lithium on the side. I just wish I had a better idea on how to connect the new transfer switch to the existing.
I think it would be better to replace the AGM and only have one type of battery. It should be possible with a battery selector but your charging parameters are different for the two types of batteries. Just asking for headaches I think. I’d also go for some type of manual switch as that’s the main problem I’ve ran into is the transfer switch failing out when a heavy load is applied
I’ve always wondered how one would fish the wires in a rig. You did a great job explaining it. This was quite the project! How much time did it take you to set it all up?
Why don’t you just run an extension cord off your inverter straight into the 50 amp plug that you normally use for shore power. All you have to do is flip your converter switch off inside your rig.
@@1fartdart I don’t have to deal with any cords. I can pull over on the side of the road and lot dock somewhere and use my inverter without having any setup or use my generator with very little… just unplug the cord from the inverter inlet and plug into the generator
Great video, thanks for the shout out. Awesome set up, I like automatic transfer switches
Ok thank you so much for this video!! I plan to put solar on my 40’ Open Range but I currently have an onboard generator, and I even have an inverter to power the residential fridge while I’m driving, but I’ll need to purchase a larger inverter to power the rest of the rv. I figured there was a way to work around buying all sorts of expensive devices and switches. But I haven’t found a video that explains it like you do. New subscriber!!
Glad it helped.
I just ran a 12gag extension from the inverter to the rear of the RV and plugged it like normal with the conversion adapter. Yes I still need to shut off the bigger draws Ac, Fire place and the microwave. But it works like a charm
thanks for the video
good idea leaving extra wire in case you have to remove it. I'm with you on making things easy.
On your next gen setup, maybe try finding an inverter with an A/C input, then drive that with a Genset. No transfer switch necessary, and also you can save quite a bit of fuel in the Genset. The A/C input would drive the loads for the camper and also charge your batteries at the same time. Happy Camping !
Anytime you fish wire when you pull your new wire go ahead and pull a PC of paracord or small line with it. That way if you ever need to pull for anything else you already have a feeder line in place.
Great vid. I’m doing a very similar setup and glad I found your install.
Overall I’ve been happy with it but I do wish I used a 3000 watt inverter
Excellent video, Barrett. Going to start this project soon. Your instruction will be very helpful. Thanks! Peace.
This is one of my favorite mods so far… the rv is in the shop and I can see what they are doing lol
I thought this was on my blink doorbell lol… but I like this one too
I'm in the same boat trying to figure things out I'm adding a complete solar system to my slide in truck camper. And I was wondering how to use the RVs existing system I was wondering if I could any field system in place which had an AGM battery. And then add solar with lithium on the side. I just wish I had a better idea on how to connect the new transfer switch to the existing.
I think it would be better to replace the AGM and only have one type of battery. It should be possible with a battery selector but your charging parameters are different for the two types of batteries. Just asking for headaches I think. I’d also go for some type of manual switch as that’s the main problem I’ve ran into is the transfer switch failing out when a heavy load is applied
Nice video Barratt! Wiring is often very complicated. 😬
We feel your pain over here on SV Ohana 🤪
We think alike! Great video.
Good advice on not running the converter from the inverter.
I’ve always wondered how one would fish the wires in a rig. You did a great job explaining it. This was quite the project! How much time did it take you to set it all up?
It was 2-3 days
@@GimpyCamper that’s not too bad, all things considered. Thanks for sharing!
What model inverter did you use?
The 2000 watt Renogy pure sine. Part of me wishes I would have just bit the bullet for a victron multiplus though
@@GimpyCamper I would really prefer an integrated transfer switch in the inverter that would support my 4k gas generator.
Why don’t you just run an extension cord off your inverter straight into the 50 amp plug that you normally use for shore power. All you have to do is flip your converter switch off inside your rig.
@@1fartdart I don’t have to deal with any cords. I can pull over on the side of the road and lot dock somewhere and use my inverter without having any setup or use my generator with very little… just unplug the cord from the inverter inlet and plug into the generator
99% of the CPAPs out there are 12v, just instal 12v outlets in the camper.
And 98% of those want way too much for the 12 volt adapter plug, but yes, I have one now