Samsung Refrigerator Inverter Compressor Control (IPM Board) Fail Test

แชร์
ฝัง
  • เผยแพร่เมื่อ 21 ม.ค. 2025

ความคิดเห็น • 35

  • @timd5597
    @timd5597 7 วันที่ผ่านมา

    I have a Samsung family hub refrigerator I'm not getting the little red light to come on at all on my inverter board Is the board bad?

  • @rohitathithya3964
    @rohitathithya3964 ปีที่แล้ว +1

    Where do you source your IPM boards? Is there a link/website where you get such parts?

    • @forevertechenglish
      @forevertechenglish  ปีที่แล้ว

      I usually get them from my local electronics market

  • @hamadahamed3655
    @hamadahamed3655 2 ปีที่แล้ว +1

    الله بنور عليك يا هندسه على الفن الجميل

  • @rolanddejesus8685
    @rolanddejesus8685 2 ปีที่แล้ว +2

    thank you very much sir for sharing...God bless.

    • @jollyscaria1922
      @jollyscaria1922 2 ปีที่แล้ว +1

      Vrey good qelcome pardes damge ok not avblibes how explaing

    • @forevertechenglish
      @forevertechenglish  ปีที่แล้ว +1

      You are very welcome

  • @EJEuth
    @EJEuth ปีที่แล้ว +1

    Very useful, thank you for sharing!

  • @jlfarm4987
    @jlfarm4987 หลายเดือนก่อน

    What happened if the red light is bliingking 5x?

  • @comlanhuberthounnou9316
    @comlanhuberthounnou9316 ปีที่แล้ว +1

    Si par exemple le circuit intégré /contrôleur du moteurt est défaillante , comment je vais démarrer le moteur, seul

  • @nastechair-conditioningser3529
    @nastechair-conditioningser3529 2 ปีที่แล้ว +1

    Thanks for sharing

  • @mariooo840
    @mariooo840 ปีที่แล้ว

    Good job, thank you very much!

  • @vadimtyutyunnik353
    @vadimtyutyunnik353 2 ปีที่แล้ว +1

    Thanks a lot!

  • @jeffreyvalencia9004
    @jeffreyvalencia9004 ปีที่แล้ว +1

    Sir what is the fault when the mother board have a 1 blink and then the refrigerator will shut down. My refrigerator is 4 years old.

    • @rickhunt3183
      @rickhunt3183 ปีที่แล้ว

      I'm not a refrigeration technician but I do understand electronics. the compressor motor is a three phase dc motor. I would direct my attention to the IGCM06F60GA intelligent power module. It's either not outputting power because it's defective or because the circuit that drives the device isn't sending it control signals to switch and control the phases ( provided you're talking about the compressor not starting ). If everything switches off including the light inside the refrigerator then I'd look at the power supply. Don't throw out your refrigerator. I've never worked on one of these, but it can't be too complicated. It looks like the board was designed by a first year collage student. Sorry I'm coming late to the party.

  • @tesfayekebede5484
    @tesfayekebede5484 9 หลายเดือนก่อน

    it is a good sort for technology how it works thanks

  • @peterphiri4262
    @peterphiri4262 ปีที่แล้ว +2

    Please sir make a video for error codes in English for air conditioning 🙏

  • @antenehwassie-y8p
    @antenehwassie-y8p 4 หลายเดือนก่อน

    How about a vidieo on turning inverter to timer system

  • @thanos_x23
    @thanos_x23 ปีที่แล้ว +1

    With your experience which are the most reliable brands and why do you think these boards fail?

    • @rickhunt3183
      @rickhunt3183 ปีที่แล้ว +1

      Why do they fail? Frankly I'm surprised they even work at all. It looks like a child designed it. If you have the money, and there's someone you really don't like, buy them a Samsung washing machine or a refrigerator. The core systems might or might not be sound, but the computer and control boards are all bullshit in my opinion. I'd like to know if Samsung designs and builds these in house or if they outsource.

  • @mhandrabat331
    @mhandrabat331 ปีที่แล้ว +1

    سلآم عليكم ورحمة الله وبركاته استادي الكريم اريد ان اسالك عن ثلاجة بها سداد قمت بتغير الضاغط انفرتر بوحد اخر جديد لان القديم تالف وقمت بتنضيف الكابلير بمادة جبيتر ولكن المشكل باقي كما هو هل لابد تغير الكابلير بالكامل وثلاجة سامسونج twing coling

  • @sanjeewahanduwala7152
    @sanjeewahanduwala7152 ปีที่แล้ว

    Very good

  • @alexisgeorgiou4247
    @alexisgeorgiou4247 6 หลายเดือนก่อน

    Dear friend i have Samsung refrigerator and the motel is RT29K5030WW , the fridge when i plug in the electricity ,is working well,and everything is fine,the lights in pcb is working well, everything started working well,my problem is PCB is not getting signal from sensors defrost, to pcb electronic plate,to give time break for resting the compressor,is working with no stop,so when is working long time (about 6-8 hours working,is giving me a signal,in pcb,10 times that my compressor having a problem and is stop working, like is have to be , everything is hot,i have checked all's the defrost sensor up and down with multimeter in k oms,and the compressor also with multimeter, and everything is fine,i think something happened with pcb,is anyone out there, can give me any advice, what happening , where is the problem ,i can not found,is anyone from experience now something ,to give me where is the problem , many thanks reading my problem

  • @Aviatore2023
    @Aviatore2023 10 หลายเดือนก่อน

    Buongiorno, ho un frigo RT53K6450EF SAMSUNG . Il problema è che il freezer raffredda ma NON congela , lo staccato per due giorni ma senza riscontrare nessun cambiamento. Contattato un tecnico che dopo vari controlli mi dice che è la scheda inverter che è guasta, facendomi notare che il led presente sulla scheda deve restare acceso ,invece risulta spento......va via dopo pagato 50 euro per la chiamata e mi comunica che mi farà un preventivo per la sostituzione , sono ancora in attesa da 3 giorni .Allora da internet ho trovato come resettare la scheda inverter e noto che il led che mi faceva notare il tecnico ora è acceso ( anzi ora è sempre acceso e sento sempre il compressore acceso) ma comunque il freezer non congela(quindi presumo che la scheda ora funziona). Che può essere secondo te? HELP ME

  • @mpologomafred7754
    @mpologomafred7754 ปีที่แล้ว +1

    My compressor not work

  • @rickhunt3183
    @rickhunt3183 ปีที่แล้ว

    The problems are the result of poor engineering, a poor design and poor quality control. If you're making a product and there's a board that's prone to failure, then clearly you don't know what you're doing. It looks like a first year college student must be the lead engineer on the team. I'd fire everyone that had a hand in designing that board. I hope this example isn't indicative of the type of work we should expect from the design team. This is clearly an example of where failure and incompetence went unchecked. Firing everyone on the design team and starting the entire design process of the product from scratch might be a wise choice.

  • @md.kamruzzaman9205
    @md.kamruzzaman9205 ปีที่แล้ว

    IPM number plz

  • @spicky2966
    @spicky2966 ปีที่แล้ว +1

    I guess you can't purchase this microcontroller.............

  • @somchaiimsoontornraksa985
    @somchaiimsoontornraksa985 6 หลายเดือนก่อน

    ทำคลิปแปลเร็วเกินไป

  • @davidgreenman-fe5ks
    @davidgreenman-fe5ks ปีที่แล้ว

    you cannot explain, big dislike,