Thanks for this video. Very similar piston+ rod setup to my ahl vag rebuild I am doing currently. was super useful to a nab for his 1st time rebuild. +1
I just assembled my rings the same as you per the wiseco instructions for my b series build Someone told me never to put any ring gap’s over the pins ? How’d she break in like normal I presume?
You wanna weigh my pp and balls to make sure they are properly balanced? Nah I matched up the pistons and rods to make sure they were all close in weight using my brothers gram scale.
Do you have a link to where you bought this piston/rod combo and did you have to check clearances when installing into the b16 block ? I have a b16a I want to change piston and rods
And as for clearances, after you home your cylinders, you are going to want to check your piston to wall clearance. And upon installation, your gonna want to check your ring gaps, and your rod bearing clearances. All of which I have videos for in my "civic build" playlist
@@davidcastillo6776 stock pistons or forged? They expand at different rates. If you are getting aftermarket pistons, they will come with a diagram showing you recommended specs for their piston
Thanks for this video. Very similar piston+ rod setup to my ahl vag rebuild I am doing currently. was super useful to a nab for his 1st time rebuild. +1
I just assembled my rings the same as you per the wiseco instructions for my b series build
Someone told me never to put any ring gap’s over the pins ?
How’d she break in like normal I presume?
very informational, very lubed up, very nice
Did you weigh each piston along with rods? to make sure it’s properly balance?
You wanna weigh my pp and balls to make sure they are properly balanced? Nah I matched up the pistons and rods to make sure they were all close in weight using my brothers gram scale.
KraftingKars it’s hard to weigh your twig and berries when you have a slit 😂
@@tonyschill8054 stay tuned for my upcoming video "My built turbo b16 civic gaps Tony's shitbox Volkswagen”
Still using these pistons?
I dropped a big fat like!
Do you have a link to where you bought this piston/rod combo and did you have to check clearances when installing into the b16 block ? I have a b16a I want to change piston and rods
www.hptautosport.com/products/wiseco-pistons-eagle-rods-honda-civic-si-b16-b16a-81mm-k542m81ap-crs5290h3d
And as for clearances, after you home your cylinders, you are going to want to check your piston to wall clearance. And upon installation, your gonna want to check your ring gaps, and your rod bearing clearances. All of which I have videos for in my "civic build" playlist
@@kraftingkars appreciate the reply, will watch the other videos
Do you have to add your own piss, our do they come pre pissed in
Lucky these came already pissed in!
What gap do I run
What motor do you have, and how much hp do you wanna push, and do you plan on using turbo or nitrous? All this will effect your gap
@@kraftingkars all motor b16a2
@@davidcastillo6776 stock pistons or forged? They expand at different rates. If you are getting aftermarket pistons, they will come with a diagram showing you recommended specs for their piston
✌💛🌻🌮