Zyltech HEVO 2.0 - Setup: Part 7

Configuring the firmware and testing.
Link to files www.prusaprinters.org/prints/...
3D Make It - Firmware
• Compiling Marlin 2 0 w...
Chris's Basement - ABL
• Auto Bed Leveling - Ma...
Dustin Corbin - Stepper driver current
• How to Tune 3D Printer...
Music
Out of the Skies, Under the Earth by Chris Zabriskie
freemusicarchive.org/music/Ch...
Wonder Cycle by Chris Zabriskie
freemusicarchive.org/music/Ch...

[@wmj8922]

Do you suggest going the duet route with this printer or to stick with RAMPS?

[@SteamLabs]

The RAMPS board is the bare minimum. The duet is wonderful. You can set up the firmware in 30 minutes and make changes on the fly from your computer or the touch screen.

[@spacespino2325]

LETS GOO

[@SteamLabs]

I kept saying esteps but I meant steps per mm.