Prepping And Wiring Motorcycle Handlebars

Prepping the handlebars before pulling cables through can prevent damage to the cables. There is often weld slag or metal shards at the weld junctions inside the bars that can cut the jacketing of wire while pulling which could cause electrical shorts. The video then takes you through the process of pulling the wiring through the handlebars. This will give you a fully prepped handlebar with control housings attached ready to install on your motorcycle.
For more information about prepping and wiring handlebars visit: rideitwrenchit...
Below is a list of parts used in this video with links:
Paul Yaffe's Bagger Nation MBB125-12: amzn.to/39zGrMG
Avon Grips: amzn.to/3zJPZjb
CAN Circuit Handlebar Wiring Extension Harness 12": amzn.to/3xrxJrX
Mason Line: amzn.to/3xUg5OM
Wheel Bearing Grease amzn.to/3zA2qhj
Website: rideitwrenchit...
Facebook: / rideitwrenchit
Instagram: / rideitwrenchit
For more maintenance tips, riding stories, or donations to help support the making of these videos, please visit my website at: www.rideitwrenc...
**Always follow the instructions found in the service manual for your particular bike. Manuals can be purchased at the dealership or online**
The information in this video is for educational purposes only. Ride it Wrench it assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use the information in this video at your own risk. Any injury, damage, or loss that may result from improper use of tools, equipment, or the information contained in this video is the user's sole responsibility and not Ride it Wrench it.