Working on a 2001 version today - we're sorting out the fact the rear axle is held on by cobwebs... welding complete (say it fast) I rang looking for new spring shackles as the old ones are toast.. parts guys we use had none/couldn't get.. Hmm.,.. rang the main stealers, they said they'd ring back.. they rang back an hour later - "parts are discontinued/NLA/We not makes 'em any more Pal/Tough tiddies..... " Blimey... Rang "We have every spring bit on Earth R Us" - they couldn't get any either..... Well good luck to folks with that... I'll make a pair, we have the gear to do that, but dunno what loads of people will do.
The metal is too thin to seam weld…that would cause distortion. That’s why people do small spots around the repair then continue around to minimise distortion.
I was thinking about that same. Even tho a lot of them is weldet only on spots but then they are overlaping and ruber filed seams which mainly fails here 😊
![[UNCUT] เก็บ "สจ.โต้ง" เอี่ยวมาเฟีย รู้ตัวคนบงการ ก่อนสั่งลั่นไก I คนดังนั่งเคลียร์ I 13 ธ.ค.67](http://i.ytimg.com/vi/o-J_p62D40w/mqdefault.jpg)
![[LIVE] : ONE ลุมพินี 91 | คู่เอก "คมอาวุธ vs อเล็กเซย์"](http://i.ytimg.com/vi/V0RkEfYFsgM/mqdefault.jpg)
Working on a 2001 version today - we're sorting out the fact the rear axle is held on by cobwebs... welding complete (say it fast) I rang looking for new spring shackles as the old ones are toast.. parts guys we use had none/couldn't get.. Hmm.,.. rang the main stealers, they said they'd ring back.. they rang back an hour later - "parts are discontinued/NLA/We not makes 'em any more Pal/Tough tiddies..... " Blimey... Rang "We have every spring bit on Earth R Us" - they couldn't get any either.....
Well good luck to folks with that... I'll make a pair, we have the gear to do that, but dunno what loads of people will do.
I hate welding these btw - it's never ending. You think you are done, you spot another hole... and another... Endless. Pleurff.
A lot parts that was discontinued goes under diferent part numbers but it is same. I had hard time to find fuel presure regulator but i made it
RIP 6:00
Weeee
First!
Damn you!
@@xorwin1236 🫢
You should have seam welded the repairs NOT just "spots" !
The metal is too thin to seam weld…that would cause distortion. That’s why people do small spots around the repair then continue around to minimise distortion.
I did, i say at the end that im not gonna show it because I you can see it in the previous clips, maybe i didnt say it properly... my bad D:
I was thinking about that same. Even tho a lot of them is weldet only on spots but then they are overlaping and ruber filed seams which mainly fails here 😊