Thanks for the video! I've ordered a Xonrich 8667 and this video helps a lot with the wiring. A few questions if I may.. 1) about the red [ACC] wire, did you connect it and if yes, where did you connect it to?; 2) the yellow [B+12V] wire, did you use it and was there constant power on it?; 3) Did I understand correct that you connected the [AMP-CON] to the [ANT] wire to give a powersupply to the antenna?
@sandroo34 you are welcome. So the acc and +12 wires did not need connecting in the end. I think they are for additional circuits. Yes I used the blue amp control to power the antenna. They both run at 12v and the antenna draws minimal amps. Had the same connection so I was be slightly lazy tbh but it works just fine.
Thanks for the video! I've ordered a Xonrich 8667 and this video helps a lot with the wiring. A few questions if I may.. 1) about the red [ACC] wire, did you connect it and if yes, where did you connect it to?; 2) the yellow [B+12V] wire, did you use it and was there constant power on it?; 3) Did I understand correct that you connected the [AMP-CON] to the [ANT] wire to give a powersupply to the antenna?
@sandroo34 you are welcome. So the acc and +12 wires did not need connecting in the end. I think they are for additional circuits. Yes I used the blue amp control to power the antenna. They both run at 12v and the antenna draws minimal amps. Had the same connection so I was be slightly lazy tbh but it works just fine.