I don’t know if this is helpful for you Phill, but on my Cowan, I placed the entire line on those cow matts. I don’t run any where near the volume you do, but I don’t bolt anything down to the cement.
Build a few crossmenbers, two flat bars welded together for an upside down T, Put a crossmenber at each leg. Drill the CM and bolt it down, wherever you want. They usually put the two extractors, side by side but running in opposite directions, theres no box passing back and forth, and the guy in the middle does the loading on both. Adjust the governor on the forklift so it aint surging.
I don’t know if this is helpful for you Phill, but on my Cowan, I placed the entire line on those cow matts. I don’t run any where near the volume you do, but I don’t bolt anything down to the cement.
Photo?
Build a few crossmenbers, two flat bars welded together for an upside down T, Put a crossmenber at each leg. Drill the CM and bolt it down, wherever you want. They usually put the two extractors, side by side but running in opposite directions, theres no box passing back and forth, and the guy in the middle does the loading on both. Adjust the governor on the forklift so it aint surging.
Lots to consider there.
You are going to have quite a setup when you are done. Do you do any custom extracting?
I help out a friend or two