วีดีโอ

Good work, love all the YJ content

😂😂 You just fuck up the Jeep

Installing these on my JL tomorrow. Have you liked them?

I wouldn't stand there

Did you jack the engine up by the oil pan??

Got to do the same thing on my 92

Did you have to remove alternator?

this is awesome!!!! I want this on my bronco

Thank you i have a 95 yj with this setup and i wasn't sure where the belt tensioner was at. Now i know the belt tensioner is the power steering pump here. Thanks again.

I just picked up one of these

Excellent video! Thanks!

Thanks for sharing. Good video.

Good job!

How does this work after a year?

Been driving standards 50 yrs I was taught you always leave it in first when parking as well as with the e brake.Nice easy repair was also taught to use the parking brake every time to stop it from seizing up.

Thanks for the video.

They are fine for a economy replacement seat, but I doubt I would ever buy them again. Your video made the assembly of the seat look just a simple bolt together job. To me it was a major PITA!! Nothing lined up easily, the brackets were all out of shape and wouldn't come into range easily with the seat bottoms. It finally came together, but it was no simple job.

I just finished putting a whole new exhaust system on my 91 yesterday. I didn’t have a hanger there, might have to weld one in. Looking good!

Thanks for sharing this! I'm about to dig into some muffler work myself. I wasn't sure if that part supported the weight or if it just held it in place, curious how your setup works out over time.

Took my stock 89 4.2L YJ to Gulches a couple years ago and had a blast. Several upgrades later I went again and had even more fun. Love Gulches. Love my YJ. I would go more but it’s about a 2 hour drive for me to get there.

Hi, thanks for that video. Did your belt squeek? or was it just preventive maintenance? My Yj 4.0 with AC suddenly squeeks very loudly this morning. I had a few squeekes before on start up in the past. Motor does run ok. Not sure if it is just old belt (7 years I think) or could one of the components have seized (compressor, altenator, pump).. I think I loosen the tension to see if all can rotate easily.

the charging part is whats got me, and how much is all this stuff to charge it

The last real Wrangler. After 1997 it were only toys for spoiled brats.

I installed this in my 87 yj. Works great, only problem is there’s so much exposed metal in the cab that it took forever to draw that heat out of everything and cool the interior down. I put a hotheads roof liner in on my hardtop and that helped some. Eventually I had to put sound deadening/insulation in and a bedrug carpet kit. Still not super cold inside but only on days close to 100 degrees

I have a 92 YJ and I will NEVER, I repeat NEVER, replace the dash speakers again. I will be floor pods or mount them somewhere else. That dash removal was a nightmare LOL. I have pods behind the seats and I think I will be getting a soundbar soon.

This video was awesome. Thank you so much.

Thats a great looking yj! I also dig the look of those tall skinny tires. Nice job!

Stock… love stock jeeps, mine is 95

Thanks for the video! I’m going to attempt to tackle this project myself!

Funny, we both have YJs, Hondas, and beautiful dogs 😃 Great video, thanks for walking me through it. Really appreciate the silent approach too. Take it easy!

Hi I recently did this on my 89 2.5 tbi, not long after installing it would start to bog down the jeep when i turned on the air. the rpms would drop extremely low at idle around 200-400. I know now that it is because its a big power draw and theres no wiring done to tell the ecm to increase rpms when ac is on. Did you have any problems like this with your jeep? if so have you done anything that fixed it? also now i have the opposite problem where my jeep idles wayyy too high when it warms up at around 1500-2500, i think it might be a vac leak but ive been putting off fixing it since when I turn on the ac it brings down the rpms anyway😅

How much is the cost

Was it worth modifying?

Did you regear after the lift? I was hoping i didn't need too with a 2.5". My shackles look upgraded, but my springs are totally flat. Im about to grab some used 2.5 RE springs, and just part out some bushings, u bolts, such. Its got 31's on there now, so im thinking i can do 33 max. But i really dont wanna regear.

That is so much work. I think I will just get bluetooth headphones and connect to my phone.

‼

Anyone know if this parking brake assembly is compatible with the 97-01 XJ as well? 😊

Fel Pro shows a different part number. Also amazon shows that part number your using doesn’t fit. 2005 wrangler rubicon 4.0

Good instruction. Thanks for not blasting me with heavy metal.

Quadratic makes a winch plate for the YJ that fits

Looks great!

Swap that battery w AGM asap😂

Great video. I have a 1993 wrangler and my problem is that the button on the inside won’t push to the lock position. It may just need to be taken apart and freed up because it used to work. Thank you for this video it definitely was educational.

Great video. Thanks for keeping it simple 🤙

I loosened all the bolts and it seems stuck on there I think the last bolt is the one im trying to figure how much do I have to loosen for the belt to break loose

Great video! I've also been without a parking brake on my 91 the 4+ years I've owned it. Super annoying! A previous owner swapped in a Ford 8.8 rear end with disc brakes and I don't know if the parking brake ever worked since then. Yesterday, I swapped all 3 cables and then dug into the rear brakes to check the status and clean them up. Things are kind of old and worn on both sides and after a few adjustments and testing, the parking brake still wouldn't hold. So, I have all the parts on order to redo the back brakes, including the parking brake shoes. I also found out my YJ never had the recall done to replace the parking brake pedal. So, literally, the only thing I can reuse is the adjuster that you replaced in this video! Enjoy your parking brake - I hope to have mine working in the next week or two.

Nice job as usual.

Gr8 video!!

Good day family and four wheel drive.

Nice work