วีดีโอ

Thank you!

What if you now have a high idle and you didn’t replace or disconnect a battery or anything else? Ty.

Only thing tThe diagram says 3 n 4 yu said 3 n 5 dat was confusing… but your video helped thank yu

To eliminate theft(putting your jeep in N and pushing it away), how would you remove the cable from the lever assembly?

Want to make some good money repairing or kitting out cam plate sensors for 2005 through 2007 Buells? These are mainly 2006 Buell XB12X Ulysses, 1203cc 103 hp adventure motorcycles. I can send you pictures and an actual cam plate with its embedded sensor. The plate is about 3 inches in diameter with a sealed plastic sensor module pressed in. Standard cam plates for any of the other Buells WILL NOT WORK. I do not want the business or money. I am retired and just want my Buells to run. Best to you. George

Did you have to recalibrate anything after the install?

Thanks bro

14mm spark plug socket and 6" extension to pull plug.

How about on a push button, my car turns off right away won’t stay on

You were very helpful like the video

No inspection on the caliper Pin and no cleaning and regrease .... Big Fail if the caliper Pin is Stuck the Pad will wear uneven and fast ! Its THE MOST importent things to check on brake service !!!

Hi can you show Electronic parking brake how to release on these tool please

Bought a brand new pump but didn’t came with the update harness. I put it on at one turn on how can I get the harness for the new pump? Thank you.

Thank you for this, i jb welded it and then it broke again after a year so its time to replace it.

This worked for my 1997 Camry. Thanks!

Your the damn man!!!

My sisters chrysler 300 swapped the pump and filter and only driver side has fuel in it. Factory plugin turns on the pump just not starting. I spliced the 2 wires and swapped them and it gets no power to the pump.

It worked! Thank you!

How do i get that updated harness

Thanks for making the video. Also what's the tube between the oil cap and head cover can't find the part online or do i have to replace the whole cover

Another video says to step on the brake

Can I rewire before taking the old fuel pump out

I need to know the location of the sensor on Rx 350 2016 plz

Ac has to be empty b4 replacing? Re charged afterwards?

Where are you located

Hello! Do you happen to have a pen part number ? My clock spring went bad and the one I ordered doesn’t have the angle sensor assembly

What is the part number for the Resistor, I have a 2014 Kia Sorento

Mechanic quoted my mom 400$ for this 🤦 doing it after work today

My pasenger window stopped. I couldn"t control from the drivers side. I was able to open the window, but i cant close it. It just stopped. What could be the issue.

@9:41, may you tell me what brand and model of spanner wrench you have?

For those who don't follow this procedure, I had success taking my 2006 matrix for a 10 minute drive reaching speeds up to 90km/h.

Worked out for me thank you very much brother

Thank you. I just spent $5 for a 2 pack of krazy glue to make this easy repair vs spending $44 on a replacement fob from Amazon or God knows how much I would have spent on a replacement from the dealership

Why not make the new fuel pump to work with the existing plug.

Hi Thanks for the information. Can we buy the CD from somewhere online ?

An ip address for a transmission? That means the TCM is inside de transmission. And theres a TCP/IP communication inside the car... uff I thought all manufacturers were requiered to use a standard like LIN or CAN

Any one can help me to find the Flasher turn signal relay on a 2009 Cadillac CTS

Much easier on the IS350 than it is on the IS250. Taking the intake off the IS250 added like half an hour to the job which should have been 30 mins max. Too bad there are no 350s here.

hi bro what kind of scanner ?

Ratchet to remove only. Do not use anti-sieze either. That's per the manufacturer of the plugs. Otherwise, good video.

So does the fuel level read correctly from full to empty ?

This is how someone stole my 2014 jeep grand Cherokee!!

So if it starts up, then is the solution to replace the fuel pressure sensor?

It helped me on my 2006 300c 5.7. The fuel pump from autozone didn’t come with instructions and after installing it, it wouldn’t power the pump. Did this with the new fuel pump harness and it worked. Thank you so much!

How can I get the wiring directions online that is the part I like most I. This video I need real site for pin out

Can you make a video of the belt ? it would be good a video that covers all the recommended changes from Acura for the 120,000 Maintenance.

Nice video- and helpful- BUT, I followed these steps, saw the actuator, but there is a large duct, or some other obstruction in the way. There is no way to access it on my 2004 DeVille. Looks like the mechanic will be getting some of my money.

Thank you having the identical blower fan speed issue;... fan only on high....!

How can we know on a car if is fitted with pull up or down sensor

Whats the procedure for a manual?