วีดีโอ

Thanks daddy

Good info. Thanks.

I have to this. Thanks for the vid

So did you fix it?

HOW much difference between this coil to a 4.0 explorer V6 06 to 2010 ?? Thanks v

You are quite an accomplished trouble shooter. A TPS can also be tested in OHMs/resistance. Disconnect, connect multimeter in OHMs. Move TPS through its range. The resistance will be very unstable with a bad TPS. You can test a new TPS the same way before installing. Results: 700 ohms to 4.2 K ohms for Ford 302 V8’s of the late 80’s part number E6AZ-9B989-C . Should be similar for this TPS? (maybe)

I had a P0301 cylinder 1 missfire on my 3.9L freestar. I replaced fuelfilter, cylinder 1 spark plug, spark plug wire, ignition coil. It's really misfiring, RPMs all over the place , runs terrible and dies. Just under 100K. Would it be possible caused by PCV valve ?

What happens when there is no relay number 9?

Do a 2009 Hyundai Sonata Have a Inertia Switch That cuts Power to the Fuel pump

*WHAT VEHICLE IS THIS?*

2005 chevy uplander. Fans dont come on. Tested fans and they work... fans do come on when you apply ground on any of the 3 relays. 1 low speed and 2 fast apeed.. temperature its been all the way to 210-215f and fans never come on. Idk what to do

What about the 2010 Ford Mondeo MK4

Thank you, this was very helpful!

Thanks from Barcelona, very useful!👏

When by passing relay and bridging 30 to 87, what guage wire should i use? Is 10 amp ok or 15 amp better? Thanks

I just love the way he's explaining everything that he's doing, letting everyone know in a very soft spoken voice and clear enough so that everyone hears what he's saying in detail 😊. Great 👍 👌 job buddy!

Thank you for sharing.

How are your thoughts so far on this mobil oil? Is the diff working properly ? I am in beetween it and the motul 300.

Not getting voltage to Inertia switch.Where do I go from there?

great you saved me

The only thing this Yankee learneded is you can bend the prongs back to make it werk.

The head gaskets got better around 03. Convinced that most of the motors get ruined by these fans not working.

The only one that actually taught me how to do it!!

Always admire the knowledge of these technicians! Many times self taught! Thank you for sharing your knowledge.

Please indicate where the switch is at for beginners thanks

Does a 2008 ford kuga 2.0 tdci have one and if so where is it located please

Mine doesn’t have hex fastener, is a push in type, but all the parts websites are showing the hex type for my Renegade. What the heck is going on with these cars? 😂

How to connect two wires to the A/C pressure sensor for a Mazda GE 626

By myself. 2:18 from a 2005 ford freestar.

By myself. 2:18

How to remove windshield wiper motor from the car.

Excellent video. Good detail... in the 70s we used to change the PCV as part of an annual tune up. They were metal back then, right on top of the valve cover and cost ~$2.50. I thought... better change it while doing the air filter at 80,000 miles! Your 40,000 mile suggestion is spot on. Thank you very much.

I feel my legs burning

Great short vid.. I think my pcv valve went out and got oil in the upper intake!

Do a 1.3 engine have one ???

Awesome, very simple, straightforward, and to the point! Thank you :)

Very good video, thank you for pointing out how to clean everything and shield the wires.

Well Done , Excellent Video ! Thank you Sir !

Saved me on my 99 crown vic. Hasnt been started since 2018. My great uncle passed away an i needed to get the full tank out of it. Thank you!

Ford explorer 2014 PowerTrain Relay stays energized (coil powered) with key off, drains battery over night. After removing the relay and putting it back it did not energize ( click on and draw current) how ever after driving yesterday and parking last night, it is staying energized again draining the battery. What energizes that relay, the switch the PCM?

Thanks...

bem detalhado o paso a paso ! , obrigado

Is there a way to remove that screw from where it is, basically one of those screws have a damaged head and I can't loose it up, the cover is stuck and i cant change the filter, just wondering if I could cut the screw and replace it easily

Shouldn't you jump 30 and 85? That's the switch inside the relay.

Thanks for this video! Short, sweet, & easy to understand. Saved me a lot of money! 💸

IT'S ABSOLUTE NONSENSE TO BLEED EVERY 2 YEARS. Driving cars for ages NEVER EVER changed DOT4 fluid, cars was 15 years old and previuso owers did not change too. never had any issues.

Geezus... Been looking for two days for a video on bypassing this damn thing to verify fuel pump was not the problem BEFORE ordering a pump and pulling the bed back from the cab to change it. Thank you!!!

so helpful, thanks

how do you know that car is leveled? i would not measure milimiter sand just put oil as much until it starts to leak.

geezus crist why u spry so much brake cleaner?