วีดีโอ

3:15 I know for a fact that a 1983 810/Maxima with the 2.4L straight 6 will start and idle with the timing off 180º. It idles at about 50 RPM and can barely move itself across a flat surface, but it runs! 😅

Did you do any trimming or anything to fit those tires? Or does the two inch lift suffice for keeping everything from rubbing?

Is this at Grand bend and is it happing October 13th 2024 Cdn Drift Series is it free to watch

I have a twin! 15 R-line tdi. Black. Forge 2” lift, currently on 265/65r18’s. Thinking of keeping that or going to 255/70r18. No tune yet. Curious how much you trimmed to make those tires fit? I see you’re in Ontario too? From Ottawa here

WHERE ARE YOU LOCATED?

Toe EGG

Works great in hilly conditions with a 42 ft camper

every ka24 has a nasty aftermarket intake. clean that thing lmfao

Hey if I can’t get my hands on a V8 model, what would be your favorite V6 configuration to tow 6500+lbs easy? Will the 3.6L gasoline engine be just as great of a tow vehicle or do the TDI engines stand alone in this aspect?

Love KA videos no matter what the content

No hills in canada? Have you been to BC? I swear they don't know how to go around a hill, they just go straight over! Drove truck up there in the early 90's. Don't take that easy way, go up the old hwy to get to Prince Rupert!

Thanks for the video! This saved me after fiddling around for hours trying to get my car to start.

What year is it and what engine does it have?

That edit when u started the car was insane!

Did the upgraded tires cause any issues

I am wondering about the year you bought, I am in cali and been looking for a Touareg, I have a 2015 golf too and requires the full DEF (adblue) system, so I am curious if as fast as the Touareg, why where you able to get the system deleted? Because if that’s the case that would really make up my mind if it affected all touaregs 09 to 2014

I love my T-Reg TDI!

W hat is you option on that 3.0 TDI diesel. I have seen a lot of bad reviews on them. Is it all hype, poor maintenance, or are they good engines?

Dude. You have obviously never driven in B.C. Drove trucks up there in the early 90's. If there was a mountain, they built a road over it. Was hauling 80,000 pounds and had loaded super B's passing me loaded at 160,000 lbs. Some of the B.C. Cats and Cummins weren't even legal to operate in the U.S.

Had the saaaaame exact problem. Think my timing might still be off by a tooth but after watching this i know exactly how to figure that out. 🤙🏽

Any links to the parts

None of that steering linkage is off-road worthy.

So I just bought a 240sx last owner did the head gasket and we’ll let’s say it wouldn’t start after that …. This video was my solution that n toy

love the editing on the video

How do y’all learn this stuff man

Oh... so no port and polish, dimpling the intake?

What’s the compression warm now?

I have to replace the PVC Valve(rubber grommets) when I replaced the PVC, is between the PVC and breather separator, the rubber vale was so bad and crumble, most of pieces was fall into the breather separator, I didn't take them out before I replaced the new PVC, This this matter?

Good lord! Where did you get your info on towing capacity for passenger cars in Europe? There are less than a handful passenger vehicles in Europe that are rated to 3500kg and even that, requires the driver to hold a special "heavy trailer licence "

I have 2006 V8 touareg tows my 22 ft . travel trailer. Up west coast mountains better yet the extreme braking works better than previous land cruisers and land Rovers going down. 33 in tires 2 in lift. Bilstein struts.

I have a 2016 v6 gas. I’m about to tow a 1985 Jaguar, which has no keys and is on 4 flats, out of a garage and down a driveway, for pickup, since tow trucks can’t get to the garage. Jaguar weight is 4400 lbs or dead, not rolling weight, but I think I can do this. Wish me luck.

You shouldn’t use a weight distribution hitch with a unibody chassis. It may not break anything but you are going to be applying stress to parts of the unibody that aren’t intended to.

@6:21 You should match indent on dis to the shaft pin. There is an error on the FSM. Also very tricky when inserting it as it can also jump. What i do is pinch the rotor and when inserting it wiggle left to right a tiny bit while looking at the top bolt sloted hole.

I am pulling my cylinder head to send it off. I hate the Ka so much.

Holy cow. I would have parted it out by the end of the compression test lol

Love my Touareg!

My s14 rear handbrake sucks it doesn't lock well, what do I do, change the brake discs and get good pads? or tighten the handbrake cable?

What happened to the only time that got broken?

I have one just like this, but I live in West Texas. No amount of facts will convince anyone these are anything other than secretary cars.

i really enjoyed watching dis learned about a few things

Those touaregs are so underrated 🇩🇪🫡 beautiful tanks.

KA timing is 20 BTDC

I loved my tregs

I have a 2014 TDI in YYC. I’m amazed at this things capability doing off-road treks and towing ability. Can’t wait to delete it

This layout looks interesting. I'm gonna miss this weekend, are there going to be any more practice days with the layout before comp weekend?

When will you guys release the rules for the sreet class?

Have u changed the transmission oil on this?

Adam LZ drifts in his events so send it

Tip for Connor: replace the word “guys” with “people” 👍

FD has there Layout Public. Cones on Both sides for the Lead so the go straight then turn 20ft down.