@6:21 You should match indent on dis to the shaft pin. There is an error on the FSM. Also very tricky when inserting it as it can also jump. What i do is pinch the rotor and when inserting it wiggle left to right a tiny bit while looking at the top bolt sloted hole.
3:15 I know for a fact that a 1983 810/Maxima with the 2.4L straight 6 will start and idle with the timing off 180º. It idles at about 50 RPM and can barely move itself across a flat surface, but it runs! 😅
I have to replace the PVC Valve(rubber grommets) when I replaced the PVC, is between the PVC and breather separator, the rubber vale was so bad and crumble, most of pieces was fall into the breather separator, I didn't take them out before I replaced the new PVC, This this matter?
Had the saaaaame exact problem. Think my timing might still be off by a tooth but after watching this i know exactly how to figure that out. 🤙🏽
Thanks for the video! This saved me after fiddling around for hours trying to get my car to start.
@6:21 You should match indent on dis to the shaft pin. There is an error on the FSM. Also very tricky when inserting it as it can also jump. What i do is pinch the rotor and when inserting it wiggle left to right a tiny bit while looking at the top bolt sloted hole.
Love KA videos no matter what the content
3:15 I know for a fact that a 1983 810/Maxima with the 2.4L straight 6 will start and idle with the timing off 180º.
It idles at about 50 RPM and can barely move itself across a flat surface, but it runs! 😅
So I just bought a 240sx last owner did the head gasket and we’ll let’s say it wouldn’t start after that …. This video was my solution that n toy
Holy cow. I would have parted it out by the end of the compression test lol
its the carhartts that do it for me
I am pulling my cylinder head to send it off. I hate the Ka so much.
Give it to me pls
KA timing is 20 BTDC
15”*
@@fabirodriguez7212 FSM states 20 degrees +/- 2
I have to replace the PVC Valve(rubber grommets) when I replaced the PVC, is between the PVC and breather separator, the rubber vale was so bad and crumble, most of pieces was fall into the breather separator, I didn't take them out before I replaced the new PVC, This this matter?
helll yeah bruther
Will chicken man ever be back in this car?
Chicken man told me favourite engine is KA24DE
What’s the compression warm now?