- 17
- 175 366
Norm Li
เข้าร่วมเมื่อ 5 ธ.ค. 2011
Headlight polish kit
These 3M headlight restore kit part #39173 - work well. Pretty inexpensive, about $8 at the store, and $5-6 on Amazon. Just tape off paint around the headlight. Clean the headlight with isopropyl and water. Then using water and the grey sanding pad provided sand the headlight. when you are all done, the the whole headlight will be hazy looking. Then dry it off. And then afterwards use the towelette provided, wipe it on the headlight. it's a real light clearcoat for the headlight. I applied it, and put the towelette back in the pouch so it wouldn't dry out, and let it the headlight dry for about 20 minutes then reapplied the clearcoat again.
I felt it worked well for the little time and cost associated with it.
I felt it worked well for the little time and cost associated with it.
มุมมอง: 49
วีดีโอ
Hand rivet gun tip
มุมมอง 214 หลายเดือนก่อน
Just a little tip to help squeeze a hand rivet gun. Saves on the knuckles when the center of the rivet pops off and locks the rivet in. I feel that it gives better control. The distance your hand has to spread and grip is the same throughout the process. as you can see, the first rivet I was having a hard time getting the river to lock in. But with the grip clamp I had no problem locking in place.
Brake hose leak stopper.
มุมมอง 1149 หลายเดือนก่อน
Just a cheap and inexpensive way to stop brake fluid from leaking from the hose when you take off a caliper. some people will clamp the rubber hose with vise grips, but that could lead to a collapsed hose issue down the line. Instead, what I do is take about 1½" of 3/8 fuel line and cut it length wise and use it on either side of the steel block where the banjo bolt goes thru. I use two washers...
2016 Kia Sorento door handle replacement.
มุมมอง 9Kปีที่แล้ว
Replacing door handle on 2016 Kia Sorento. the smart unlock button stopped working. Very simple to do. Can be done in just a couple minutes. Door handle can be found on Ebay for approximately $40-$60 depending on what seller you find.
Autopage alarm/remote start TX-43LCD remote not working.
มุมมอง 1.7Kปีที่แล้ว
Autopage remote not working. Remote was in intermittently working. Discovered that it didn't seem to have enough output unless you were touching the antenna area with your hand or touching it to your body somewhere. Autopage Tx-43LCD remote
2007 Chevrolet Suburban Wheel bearing removal.
มุมมอง 109ปีที่แล้ว
Doing wheel bearing on friends 2007 suburban and the bearing was stuck and rusted in there. After removine everything, I tried pounding on the flange to get the bearing to release from the knuckle and it wouldn't move. I even tried bolting the wheel back on to pound on the rubber on the wheel, as sometimes with the extra leverage and a bigger sledge hammer I have gotten bearings to pop off that...
2005 Chevrolet Silverado/Suburban/Tahoe manual HVAC LED polarity.
มุมมอง 137ปีที่แล้ว
Polarity location for positive side for LED placement when upgrading/replacing burnt out incandescent bulbs.
2005 Chevrolet Impala 3800 water pump removal/installation tip.
มุมมอง 811ปีที่แล้ว
Just a small modification I do when installing these 3800 water pumps. The last bolt is right inline with the power steering pulley, kinda a pain to get at. So what I do is fully remove all the other bolts, then loosen the one behind the pulley only a couple turns. Note: the tensioner pulley is removed for accessibility. Then I'll take and snap the water pump off. it will break right across the...
2014 Chevrolet Silverado rear axle c-clip removal.
มุมมอง 8Kปีที่แล้ว
2014 Chevrolet Silverado axle c-clip removal. I had a a hard time getting the axle c-clip out. Discovered you have to position the carrier in just the perfect position. You want to remove the retainer bolt, and then rotate the carrier to the point when you rotate the carrier the big center pin will be held against the top of the differential housing. Then you can push the axle in and remove the...
2005 Chevrolet Tahoe fuel vapor canister.
มุมมอง 253ปีที่แล้ว
Friend was complaining about gas pump shutting off after about 10-15 seconds. The vapor canister was bad. Caused likely by prolonged over filling. Gas can get the vapor line, causing the charcoal pellets to swell and turn to mush, thus not allowing proper fume venting, causing the gas pump to turn off thinking its full. I've never seen none this bad, to the point that gas was still able to be p...
2005 Pontiac Grand Prix trunk release
มุมมอง 20K2 ปีที่แล้ว
2005 Grand Prix. Just a little trunk release function I thought about trying to see if it would work. you can release the trunk from the passenger side by holding the unlock button for about 3-4 seconds, just like on the driver side. Nothing big or special, just figured I'd share it. Might coming in handy for diagnosing if someone says they can't get trunk to pop from driver's door switch.
2005 Ford Taurus heater core flush
มุมมอง 2.4K2 ปีที่แล้ว
Friend was saying that his car had little to no heat. His heater core had some blockage and was running thru the bypass tube instead of going thru the heater core. The actual heater hose connections are hard to get to. So I used the input and output from the motor, and clamped the bypass tube to force the water thru the heater core. I back flushed the heater core and that took care of the no he...
2007-14 GM Chevrolet Tahoe Impact sensor
มุมมอง 2.4K2 ปีที่แล้ว
Bumper impact sensor replacement. I believe that from 1999 on up are similar on GM platform truck/suv line. They are notorious for getting corrosion and tripping " Service airbag system". The guy had it at a shop and they wanted $1200 to replace these. Very easy to take care of yourself. I disconnect battery, let it sit for 10 minutes, pull the four 15mm bolts that hold the skid plate on, disco...
Silverado 2500HD radiator drain.
มุมมอง 4.7K3 ปีที่แล้ว
2001 Chevy Silverado 2500HD 8.1 liter, 5 speed allison transmission. Radiator drain tip. I'm sure applies to other years/variants. On the driver's side there us a tube that is stowed pointing up, pull it off and install it facing down and you can collect it in a empty coolant jug. Will save on coolant running along the frame and dripping on you later.
2007-14 Suburban/Tahoe/Silverado/Yukon blend door actuator locations.
มุมมอง 115K3 ปีที่แล้ว
2007-14 Suburban/Tahoe/Silverado/Yukon blend door actuator locations.
2020 Silverado 3500HD L5P Duramax Minnesota Cold Start
มุมมอง 11K4 ปีที่แล้ว
2020 Silverado 3500HD L5P Duramax Minnesota Cold Start
What about the back? My air in the front works fine but the back never blew out cool air. I just did my air compressor. Deep vacuumed it and all.
thank youuuuui
Thanks Norm! Super Helpful.
Great work! Thank you!
Mode door actuator. Is that the one that allows a change from hot to cool air or is it the one that changes airflow positions from dash to floor
Thx bro I will try this cause when I changed the power steering pump it took FOREVER..dont want to take it off again lol
This is an oversight, but it doesn't work if your car battery is dead, making my jumper cables useless 😭
What is mode door? What's it control?
The direction of flow
The direction in which the air flows out.
You Sir, are a Saint and a Scholar. Couldnt find location data on these easily, Ironically these are in the exact same locations as my 03 trailblazer from years ago.
Gracias muy útil, compré un prix usado y se borró todo ,no se ve ningúna marca ,no encontraba como abrir
Thank you for the information. God bless you.
So does the mode door actuator control heat & ac for the back row seats? I’ve already replaced the blend door actuator under the panel in the hatch and it’s still blowing out hot air. 2008 Suburban
I can’t switch from fresh air to recirculation, and my a/c symbol flashes but it never turn on.
Thanks
So my passenger side doesn't change Temps stuck on cool no matter temp change and my rear vents in roof are all stuck on heat when ac is on and now only get heat from defrost. Idk which actuator at this point i need to change
Do you need to reprogram it? Or does it start working right away when you replace it with the new one?
It just works. I didn't have to anything else.
Thank you so much lol
Thank you for information
I was ready to throw my remote out! you saved me some money!!
Anyone know how to program the remote start please???
Did you have to drain the coolant when taking off the 2 large hoses?
Thank you Sir!! you just help me a ton
Thank you
Super helpful thanks. TRQ made one but literally did not explain what each one was.
🔥
THANK THE LORD😂
Just what I needed. I'll go try and see if it works with mine. I took the driver's side panel off for now and need to get at my tools in the trunk.
Once again visiting this video as a reminder of their locations. Thanks again for this!
Does this work for the rear door as well?
THANK YOU!!!
Could I manually switch the temperature control too cold air
If you manually switched it to cold, you would probably have to take the actuator motor apart and rotate it manually and then it would be stuck on coldIf you manually switched it to cold, you would probably have to take the actuator motor apart and rotate it manually and then it would be stuck on cold. Without the actuator on their, the door would probably just flop around and heading on how much air pressure is on it.
❤❤❤
Thanks a lot. Saved me a lot of time and money
What is the point to leaving the large pin in and rotating it up? In having the same issue and trying to find the correct way to remove the c clips.
I think it was the only way that I could get the right clearance to pull out the block in the center. I think gravity helped shift the other parts in the carrier as well. I know I spent probably 45 minutes or so trying to remove the center square block. I wish I TH-cam would let me post a screen shot. I'd screen shot the Alldata page with the directions. I over looked it originally and tried in multiple other spots and couldn't get the block to come out. After 45 minutes I reread the procedure on Alldata word for word and realized I didn't have the pin in the right spot.
Thank you I now know it’s my switch on the door not the trunk relay
Glad it helped you. I just one day thought to try it to see if it would work, and sure as heck it did. So I thought I'd share it.
This is the same for 1999-2007 as well
My 2008 Tahoe blows cold in the back and warm in the front. Which one would it be.
In the front, is it dual zone (driver & passenger)? When you change the temperature does it change at all?
You are THE man! Alldata has nothing for these components. Lifesaver!
I just tried this! That hose drains the Transmission Cooler built into the Radiator!! Not the Coolant!!! Luckily I noticed the Red Fluid before it all drained out
I have an 01 GMC Sierra 4x4 Dually with an 8.1 & this just saved me from making a big mess! It’s right where you said it was..Thanks!!
Great video. You helped me
Thank you so much!!!!
Thank you for sharing! About to do this tomorrow. Nice to get a step by step so that it goes smoothly. Seems to be common that the passenger side button fails. 🧐
We were suprised that the passenger side went bad as well. Especially since for us, it only gets 10% the use of the driver's side gets. Very easy to do. One thing I'd say is make sure the rubber gasket under the handle is backing place correctly. Mine wasn't totally seated correctly from removing the old handle, and when tightening the screw back, the cover would tighten down and sit just a little off from the handle. I just pulled it off and made sure the gasket was clipped back into the door correctly and reattached the cover and all was well.
Gracias por compartir
Thank you for the video
So I finally got my clip out after removing both pins and after taking a sledgehammer to get the axle to push in lol .... now my problem is getting the clip. back in - any trick for that?
C clamp on wheel hub to press it inwards. C clamp on hub and other side of clamp where the brake caliper bolt mounts to axle. Very easy had the same issue .
Get your Tongue out.
are they all the same part number
does this have a petcock or not?? cant find mine on '04 2500 suburban 8.1l
In the truck I was working on, it was on the driver's side corner, right where the tube goes into the radiator- you can see the circular hole, that's where the drain was.
@@normli8606 i appreciate it, cant seem to spot it, maybe i have an aftermarket non-factory radiator
@@bradleystevens2956 , or possibly that year doesn't have one. Would be down low, near the mount.
There hardly any room dumb block
Love it man. Thank you so much. Was going crazy trying to figure it out. Thanks a million.