New Floor going in my C10 Squarebody
ฝัง
- เผยแพร่เมื่อ 19 ต.ค. 2024
- This week I get the last of the rusty inner rocker panels cut out and get the new floorpan patch panel ready to go into Steve, my 1980 Chevy C10 Squarebody.
Eastwood Seam Splitters - amzn.to/3ZrKkLw
You can find me on...
Instagram / Facebook / TikTok @goodenuffcustoms
Give me a shout at goodenuffcustoms@gmail.com
Nice!! At least now you gotta peak through the cracks to see the shop floor. Looks awesome
Thanks! It’s a nice change!
Daaaang!! Jackson lookin sharp!!!
Yep, finally cut that mop of hair off!
Looking gooder every week. 👍
Thanks!
Helping the algorithm, dropping a comment. I'd have fought with that pan for about 10 minutes before running a zip right up the trans tunnel...
I had the same thought! Luckily it finally dropped in.
Bruh, I'm a new subscriber. You've done something that most shade tree's never try, much less get it this close. I don't know how much your skills started at. But, like I tell customers all the time, it's basic common sense. Your boy could benefit tons from just watching you work. Again, I'm not trying to critique what you're doing, even a little.
Thanks! There’s no real skills to speak of, I tend to just jump in and figure it out as I go!
Nice video. What kind of light are you using inside the cab...
I have a couple of LED lights off Amazon. There’s a 4ft with magnets zip tied to it attached to the roof. And there’s a 2ft LED with a magnet zip tied on stuck to the dash
Why didn't you use the whole floor ...
Couple of reasons, it didn’t need the entire floor replaced and to pull the whole floor and replace it I would have to have pulled the cab. I just don’t have the room to pull the cab off at the moment.
Dude!! Way too much talking. I just didnt have time to watch the whole thing although I wanted to.
I am a talker, not much to be done about that. Come back later and watch through when you have the time!