Ya know, I was thinking; maybe you wouldn't have accidents if you took all that crap off your vehicles, it's not like you'll lose it in a parking lot of a stadium.
This may be a dumb question, but with the wack that engine block took, combined with spinning parts coming to an instant dead stop, isn't there a good chance of that block being warped, or microcracks that could turn into major cracks?
15:30 What torque setting do I set these bolts? As tight as you can manage with the lever!
Nothing whatsoever to do with overloading it....said no-one ever.
Я думал они по привычке заварят и двигатель и коленчатый вал.
Обязательно заварят, и сделают рем-комплект!
@@user-gf1uq5eg8z А так вот откуда запчасти. Я то думал они новые с барской руки поставили. 🙂
Totalny permanentny CHAOS !!!, ciągnik cały ustrojony jak wóz cyrkowy, ale PODSTAWOWYCH ŚWIATEŁ DROGOWYCH I KIERUNKOWSKAZÓW BRAK!
It must have been quite an impact to break a tractor in half, hope the driver is OK!
these people dont know the difference between using equipment & ABUSING equipment.its no wonder everything is junk.
Well at least they repair and recycle. In the west we do not have any mechanics just assemblers
See the problem is it’s in two pieces…
I believe almost all those bolts in that engine have to be torked to a specific "pound" psi.
Be ok to the nearest two or three turns😂
Ух ты какой умный
Do you know if they enforced weight limits on vehicles half the country would lose their jobs
Torque wrenchs are so overrated and that motor is as clean as a Kia motor should run for a good couple weeks
Good job 👏
Ya know, I was thinking; maybe you wouldn't have accidents if you took all that crap off your vehicles, it's not like you'll lose it in a parking lot of a stadium.
C'mon guys i'm all for saving some coin but reusing piston rings???
Their fine. I'm sure this is the 3rd rebuild this week on that engine.
@@zuzu4wd bwahaha
This may be a dumb question, but with the wack that engine block took, combined with spinning parts coming to an instant dead stop, isn't there a good chance of that block being warped, or microcracks that could turn into major cracks?
No, it's on the opposed side of the world, so everything rights itself 15 minutes after the impact.
They can fix anything over there just watch and be amazed , heck they weld crankshafts back together ! Really .
How do you fracture a crank shaft?
front end got smashed off and end of crank n pully left the chat
Hourly maintenance has been strictly observed on these machines and it shows….
معدات التصليح { تقليدية } ، لكن نشطون في العمل
These people brilliant
Eu admiro esses caras, realizam qualquer trabalho árduo com entusiasmo.
@FabRats In my mind I hear the guy tightening the piston rods saying "click click ".
Дай им из рельса трактор они сломают
🇹🇷🇵🇰🇹🇷🇵🇰🤙