Nice job guys!!! You now have one of the best videos on you tube for an install. I"m putting in a Webasto on a Promaster as well. Thanks for sharing and leaving links to all the parts.
Thanks for the video very helpful with it installed under the passenger seat. Were you able to get sufficient heat to the rear of the van or the bed would be thanks.
Absolutely. We ended up running a short 2 piece aluminum duct that had a swivel. so we could shoot it down the walkway instead of at the cabinet. Though we've done
Thank you so much for making this video... it gave me the confidence to tackle this same project with my Promaster. Was the foam gasket enough to give you the clearance you needed over that horizontal bar behind the seat? Or did you have to improvise somehow?
There was barely enough room with only the gasket. May have not adjusted slightly when cranking down bolts. But if we did again we would add a short riser to clear the bar and allow for a duct vent or duct hose to fit onto.
Great video, Nicely explained install 👍
Nice job guys!!! You now have one of the best videos on you tube for an install. I"m putting in a Webasto on a Promaster as well. Thanks for sharing and leaving links to all the parts.
Thanks so much, Lawrence!! Good luck with your install!
We’re doing g the same thing but I’m really nervous about the wires. We’re going to put in a wood spacer to raise it up. Thanks for the video!!!
Best Webasto install video for the ProMaster EVER !!! Now I have the confidence to do this install myself! THANK YOU ‼️
Glad it helped!
This is helping me out a lot. Thanks so much for documenting your experience!
just to confirm, which side does the exhaust pipe go to? The passenger side?
Nice work on the install!
Thank you! :)
The fuel pump should never be horizontal it should always be on an angle.
Thanks for the video very helpful with it installed under the passenger seat. Were you able to get sufficient heat to the rear of the van or the bed would be thanks.
Absolutely. We ended up running a short 2 piece aluminum duct that had a swivel. so we could shoot it down the walkway instead of at the cabinet. Though we've done
Thank you so much for making this video... it gave me the confidence to tackle this same project with my Promaster. Was the foam gasket enough to give you the clearance you needed over that horizontal bar behind the seat? Or did you have to improvise somehow?
There was barely enough room with only the gasket. May have not adjusted slightly when cranking down bolts. But if we did again we would add a short riser to clear the bar and allow for a duct vent or duct hose to fit onto.