@@nevinkuser9892you really don’t, we did a timing belt and water pump on a j30 like 2 days ago and the crank pulley bolt came off with the Hercules 1/2 inch impact form harbor freight. And if that doesn’t work you can always pull fuel pump fuse and attach a breaker bar to the crank bolt wedged between the control arm with the crank pulley holder tool from auto zone that’s 20$ and crank the engine. The starter turns the motor and the breaker bar holds in place that’s normally enough force to break it free
Should have started with the impact tool bruh😂
At this time my Impack Not strong enough to do this Job. Lol
Im Breaking this Bolt loose first and finish it off with a Tiny Impact 😅
Need a 1 inch impact and 50 hp compressor. It'll set you back 10,000 bucks.
@@nevinkuser9892you really don’t, we did a timing belt and water pump on a j30 like 2 days ago and the crank pulley bolt came off with the Hercules 1/2 inch impact form harbor freight. And if that doesn’t work you can always pull fuel pump fuse and attach a breaker bar to the crank bolt wedged between the control arm with the crank pulley holder tool from auto zone that’s 20$ and crank the engine. The starter turns the motor and the breaker bar holds in place that’s normally enough force to break it free
اتبعت الطريقة هذه نجحت معي و واستطعت فك صامولة بكرة الكرنك
Super pomôcka
Ďakujem.
dude. thank you.
Happy to help
My impact is all you need.
Let that socket wrench brace itself on the ground and turn it over. The starter will break it free has worked 5/5 times for me personally.
True but this engine on the floor dosent start lol.. But becarefull some engine spin counterclockwise
That’s like picking a lock and then using the key after you get it turned 😂
Thank you, how do you get the pin out of it's stuck and can't grab it?
Try to chisel it out with a hummer, good luck hope you get it out
I will try that next time I'm doing something with it again
Why not skip the ratchet and just use the impact
@@01abihsotuse a breaker bar to get it started to save your impact.
One reason to make the video a little longer..lol
man mine has 4 10mm bolts then one big 30mm bolt and i cant get the 10mm bolts off
Your a goat bruh! 😊
Why not keep the belt on?
Put a impact on it!
If there's no compressor available and no other impact guns work, I'd try this.
Der Rostlöser 😂😅😂
Там жидкий ключ не поможет, только ударный инструмент
Да а потом резьба на натяжителе разбивается
😮😮😮
Won’t work. Sometimes even 😮heat is needed
on these 😅😮😮
Un profesional
Was only done in the garage shop with lowbudget 😢😟
Old school trick too bad
1/2 inch impact take it right off bro wasting time