Radio calibration get no green in the UI, where it's supposed to have green bars that indicate the positions of the controls, and in the end I get this message "Bad channel 1 input, cancelling".
hey when the aircraft is in our hand and in takeoff mode, the motor runs. however, when switching to other modes, the motor stops. When we try to start directly in loiter mode or other modes, the motor doesn’t run at all. sometimes it works, and sometimes it doesn’t. do you have any idea
@@feuwza2474 first start with angle mode after takeoff try other modes. Because lioter and althold mode you need to give more than 50℅ throttle then only it will take off.
Bro pixhwak drone getting potential thrust error while checking for any errors in drone giving throttle without propellers for sometime it gives potential thrust 2 or 4 like this
hi how can i check if my drone esc is calibrated perfectly as of now i am using servo output in the mandatory hardware section which showed that one of motor is spinning slow how can i correct that ???? also is that the issue calibration error as my calibration was sucessful bcz in stablise mode my drone is tilting and in the servo output function it showed my motor 4 is spinning slow
![ESC calibration APM2.8 | All motors not spinning at same time problem [SOLVED]](http://i.ytimg.com/vi/P-HbV_d7dIU/mqdefault.jpg)
Thank you very much mate ,very very useful 👍💖🦅🦅
How about disarming? Do you go down and do the left?
Radio calibration
get no green in the UI, where it's supposed to have green bars that indicate the positions of the controls, and in the end I get this message "Bad channel 1 input, cancelling".
thanks a lot, thanks of you I did , it happend, thank you for your effort with my best regards
Thank you 😊
hey when the aircraft is in our hand and in takeoff mode, the motor runs. however, when switching to other modes, the motor stops. When we try to start directly in loiter mode or other modes, the motor doesn’t run at all. sometimes it works, and sometimes it doesn’t. do you have any idea
@@feuwza2474 first start with angle mode after takeoff try other modes. Because lioter and althold mode you need to give more than 50℅ throttle then only it will take off.
@@DiyDot3d we using fixed wing
@@DiyDot3d also we give more than %50 throttle
Bro pixhwak drone getting potential thrust error while checking for any errors in drone giving throttle without propellers for sometime it gives potential thrust 2 or 4 like this
@@universaltech4630 first do esc calibration properly it will solve problem
hi how can i check if my drone esc is calibrated perfectly as of now i am using servo output in the mandatory hardware section which showed that one of motor is spinning slow how can i correct that ???? also is that the issue calibration error as my calibration was sucessful bcz in stablise mode my drone is tilting and in the servo output function it showed my motor 4 is spinning slow
You need to do calibration for sensors (gyro, acceleration).
sir mera drone upar sea necha aaya gaya battry sakena sea uskea bad armed nahe ho raha nea give me some solution
Connect flight controller to mission planner and check
@@DiyDot3d but it doesnot show any problem
@@DiyDot3d can you make apm flight controller contuniously blink 1 light only
ghek,
cung hay