Thanks so much for taking the time to record and post this video. It is a great help to us novice home-repair folks. Just like having an expert working with you!
Thank you for posting, this was incredibly helpful! Just installed a similar aluminum vent on my garage roof, and it immediately made a big difference in air temperature. My garage roof shingles are a bit more layered but the same rules applied. I used a flat bar, and I found that the roof nails were easier to get out after cutting out the opening in the roof. Rather than cut out a big square I chose to cut out a circle between planks and thereby keep the wood planks mostly intact. I also applied a ring of clear roofing sealer inside along where the metal cylinder meets the wood, and along the sides and over the nails on the outside. Looks great!
Thanks so much for taking the time to record and post this video. It is a great help to us novice home-repair folks.
Just like having an expert working with you!
Pros like you have helped me maintain my built in 1954 house here in Austin, TX. Thanks.
Thank you for posting, this was incredibly helpful! Just installed a similar aluminum vent on my garage roof, and it immediately made a big difference in air temperature. My garage roof shingles are a bit more layered but the same rules applied. I used a flat bar, and I found that the roof nails were easier to get out after cutting out the opening in the roof. Rather than cut out a big square I chose to cut out a circle between planks and thereby keep the wood planks mostly intact. I also applied a ring of clear roofing sealer inside along where the metal cylinder meets the wood, and along the sides and over the nails on the outside. Looks great!
Great video...didn't realize it was soo easy...very quick with that flatbar too
nice of that roofer to have put some tar paper over the plywood huh?.....lol
where the hell is the roofing felt on that existing roof?
Good Job - Pre-cut and the flat bar master awesome ;-)
Make a pilot hole next to the truss and shove a piece of wire through the hole...cut the opening on whatever side the truss isn't.
Great video! What about installing a roof vent on metal roofing? We live in the country and we have metal roofing.
What method did you use to know, if you are going to be between the rafters when you make the cut? From top to down in between the rafters?
Great video! Once your home gets old it's good to replace the vents
Awesome Video, Thank You.
Nice job, everybody else is a roofer,never being on a roof,but they call themselves professional roofers.
How many vents do i have to have in my roof? One per side of the house?
Thanks.
Something wrong yeah no underlayment ...
quick and easy,,, good video , one question should you use polyurethane around edges??
bang the roof you will find stud on both sides cut in the middle
thanks man i do try my best to always do better then everyone else. kind regards
good job
You forgot to say sorry
Thank you!!!
yes sir
you sure can
dose not matter
what hole dumb dumb,,,,,