Peugeot 308 heater fan not working try this, Murphyslaw
ฝัง
- เผยแพร่เมื่อ 16 ต.ค. 2024
- this block connector was burnt out. I did push together and clean the pins on both sides and got it working again. I added some extra wire the same size to help bypass the connector.
there is plenty of ways to do this I just used the most simplest way for what I had on had on hand
I tested the fan it was working when I powered it with 12v. I also tested the heater resistor wiring
After your repair did you notice any warmth from the cables? I used some connectors and can feel some warmth, not hot though.
My 308 2019 1.5 hdi the heaters blow cold if i put to 20,21,22,23c ect but if i put high like 24 or higher i get some heat do you think this could be the problem?
I am sure it was fine before cambelt and pump change 🤔 i also get a droaning noise once my engine is abit warm at idle but when cold i have no noise so something that changes with heat.
Didnt get this either before the belt and pump change and the pump has been changed twice which no change 😖
Hi I'd say it needs bleeding there is a small cap at the back of the engine on the heater core pipes it's like a valve cap on a tyre . Undo it till coolant is coming out
Yes I have done this, someone told me earlier that if heater is on 22 or 22c ect heat won't come out and his is the same but I find that bizzare how that's normal I shouldn't have to have it on 24 or 25 and so on just to get heat surely 🤔🤣 @@murphyslaw2020
@Antsummerfield83 your getting the pre heater heat I'd say that the little bit of heat your getting maybe.
Not the same car but very similar setup might be worth a look you can see to pre heater etc
th-cam.com/video/0vZ-pvWLHuY/w-d-xo.htmlsi=Q_8zbwCYVp4aFUqQ
@@murphyslaw2020 thank you do you think this could be down to the matrix radiator core that needs replacing or electrics
@Antsummerfield83 if I remember correctly there could a bleed screw on the side of the engine on the thermostat might be worth a look
What gauge wire are you using? Need to have a look at mine.
Hi I can't remember but just make sure it's not smaller than the original Wire.i just had some wire in the toolbox from another job the same size .Sorry for not been more helpful
What Was your fan doing ? I have one.. the fan comes on and off intermittently at any fan speed, so I assume it’s not a resistor.. so I assume it’s the fan itself or maybe this wiring going to it?
Hi I can't recall 100% if it was working or not. Have looked at the wiring its very easy to get at .let me know if it is that plug that's your problem.
I remember powering the fan and It ran then I followed the wiring back to this point in the video
@@murphyslaw2020 I checked that plug but it looks in perfect condition, where is the resistor on them?
@@seanbarr582 its beside the fan under the dash. You probably nedd to take out the glove box if its a rhd.
I tryed this didn’t work for me unfortunately
Might be fan just dead
Oh my god 😂😂😂