Introduction to Single Phase Inverter INV 01 using Arduino - Part 01

[@janradlinski3787]

Hello, can you share the schematics?

[@PYTHAMAXX]

Good work

[@FambiTech]

Thank you so much 😀

[@Classic_clips123]

where can i buy the module ????

[@FambiTech]

Where are u loacted? Please whatsapp @ [phone]

[@jpbef8677]

Good morning,
thank you for these superb videos. where do you find your power module?
thank you for these videos

[@FambiTech]

Hello! The modules are made by us and is available for sale.
Thank you..

[@yastop2111]

Can you use Arduino
for 3 phase VFD thanks 😊👍

[@FambiTech]

Yes. Please follow part 06 and 07 for variable voltage and frequency.

[@yastop2111]

@@FambiTech 👍

[@davidrodriguez639]

Great job :) One question, what is the function of the two MOSFETs next to the optocouplers?"

[@FambiTech]

Those are 2n7000 mosfets. Output from optocoupler are inverted, so mosfet is used to again invert the signal.

[@BhagyashreeGolegaonkar]

Can you provide circuit diagram of inv01

[@FambiTech]

Whatsapp your requirement. [phone]

[@vikashtechnicalchannel995]

सर जी आपकी विडियो हिन्दी में भी बनाए ताकि हमें भी कुछ समझ में आए

[@FambiTech]

@@vikashtechnicalchannel995 ok sir

[@mankaldim3633]

ياخشىمۇسىز ، سىز بۇ لايىھەنى ئورتاقلىشالامسىز

[@dsponline_0]

That's simply H bridge

[@FambiTech]

Yes...simple h bridge 👍

[@dsponline_0]

@@FambiTech I think you should add levels at least 5 levels and also show the effect of inductive load on the output waveform .

[@FambiTech]

@@dsponline_0 five level is covered. And the load part....you can give it a try 👍