Thank you again for those of you that stuck around through the few technical difficulties. I will continue this escapade next week, Jan-9 at 3PM PST. See you all there.
How/why did you decide on the SKR Turbo? Someone suggested I do a Pico. Tried looking at BTT's site and kind of at a loss what the differences are besides things like number of drivers.
Sorry for the late response. I have an Idea for a slicer tuning video in the future. As far as printing these parts, they are structural so I would print ether a good PLA+ like esun or a good PETG like Hatchbox. 5 shells, 5 tops and bottoms and 30% infill. Speed 60 inner shells, 40 outer shells. 60 infill.
@@EtherealProject3D thanks for the reply! I've printed the top bracket a couple times in esun pla+. I don't know what I'm doing wrong but for the life of me I can't get it to snap in, the top tab breaks off. Sorry for being a problem child!
Thank you again for those of you that stuck around through the few technical difficulties. I will continue this escapade next week, Jan-9 at 3PM PST. See you all there.
How/why did you decide on the SKR Turbo?
Someone suggested I do a Pico. Tried looking at BTT's site and kind of at a loss what the differences are besides things like number of drivers.
A friend had gotten one for his enderr 3 and seemed like a good choice. And the firmware is easy to install.
Can you do a video on recommended print settings and how to install your spool older on the desk there?
Sorry for the late response. I have an Idea for a slicer tuning video in the future. As far as printing these parts, they are structural so I would print ether a good PLA+ like esun or a good PETG like Hatchbox. 5 shells, 5 tops and bottoms and 30% infill. Speed 60 inner shells, 40 outer shells. 60 infill.
@@EtherealProject3D thanks for the reply! I've printed the top bracket a couple times in esun pla+. I don't know what I'm doing wrong but for the life of me I can't get it to snap in, the top tab breaks off. Sorry for being a problem child!
@@tpalshadow how are you trying to snap it in? There should be no bending of the tabs required.