Hi, thanks for uploading this very helpful video. I’ve just recently purchased Mr Carve M1 Pro. I’ve been trying to set up the chuck/rotary extension on LightBurn and have encountered a few issues. While the rotary seems to move during test, it doesn’t appear to move when I start the actual job. I would be most grateful if you could kindly offer guidance or assistance with this process. Thanks,
Hi Other than the test, I haven't had time to run a job on the rotary or roller. I assume you are using the Beta version of Lightburn, I guess certain things may not be working yet. I will try it as soon as possible, this weekend probably.
Yes, I believe I’m using the 1.712 pre-release. That sounds great, thank you. I’m looking forward to seeing it. Also, do I need to adjust anything else other than adding the confiq file in LightBurn, as you mentioned in your previous video about adjusting it for the BSLsimpleapp? I found two config files in simpleapp folder one as BSL and the other one starting with Lloc I believe. Which one do I use?
@@WaqasZahoor-r7e Spent the afternoon filming for youtube walked in to the house and now can't find the SD card that was in my pocket. I give up... Lightburn will control the rotary roller, I didn't get time to try the chuck. Look at the settings, particularly the roller diameter and steps per revolution. Match the motor settings to BSLappsimple where possible.
Hi, thanks for uploading this very helpful video. I’ve just recently purchased Mr Carve M1 Pro. I’ve been trying to set up the chuck/rotary extension on LightBurn and have encountered a few issues. While the rotary seems to move during test, it doesn’t appear to move when I start the actual job.
I would be most grateful if you could kindly offer guidance or assistance with this process.
Thanks,
Hi
Other than the test, I haven't had time to run a job on the rotary or roller. I assume you are using the Beta version of Lightburn, I guess certain things may not be working yet. I will try it as soon as possible, this weekend probably.
Yes, I believe I’m using the 1.712 pre-release. That sounds great, thank you. I’m looking forward to seeing it.
Also, do I need to adjust anything else other than adding the confiq file in LightBurn, as you mentioned in your previous video about adjusting it for the BSLsimpleapp?
I found two config files in simpleapp folder one as BSL and the other one starting with Lloc I believe. Which one do I use?
@@WaqasZahoor-r7e Spent the afternoon filming for youtube walked in to the house and now can't find the SD card that was in my pocket. I give up...
Lightburn will control the rotary roller, I didn't get time to try the chuck. Look at the settings, particularly the roller diameter and steps per revolution. Match the motor settings to BSLappsimple where possible.