Husqvarna 372 W/ 272 Piston Tips And Tricks And How To Set Intake Roof Height With Piston Swaps.

Explaining how to successfully build a Buckin 371 style build W a 272 piston. Explaining how to put Epoxy in you cases and cylinder. Showing how to measure your machined pop up on the piston. Showing how to measure the intake roof height with the piston. Showing a flexhone for 52-54 mm bore The right way to break in a 268 and 272 piston in a 372 because those pistons are a little tighter tolerance so the cylinder might get slight score marks. Just idle it for 1 tank inspect it if the cylinder if scratched up on intake side pull the cylinder the rehone it deburr and sand piston edges. Idle for 1 tank and it should be good.

[@matthewbutcher203]

Don't you know you can't break in a saw idling? 🤣 I've idled my saws in all my life . I mentioned it on a forum and got flamed hard. so much so that i disassembled a perfectly good saw and took photos and posted them ...the inside of my saw looked immaculate, Don't let haters get you down bud good info keep sharing

[@kennytheguitarfanatic054]

Thanks I got my saws ready to cut but there is 3ft of snow were I go to cut have to wait till weather gets better to run saws.

[@christophercollins3460]

Kenny you have a lot great advice to share. Hope to see more content like this from you Kenny. Till next time 🪓🌲🤘🏻

[@AkershusogstfoldTreservice]

Hey Kenny, great video
Do you have any pictures of when you used jbweld in case to raise the compression?