Home made bldc controller 3wire,(Type-6).
ฝัง
- เผยแพร่เมื่อ 24 มี.ค. 2023
- Here I am going to make another type of home made bldc controller
Here the controller is 3 wire system and hence i have used 6 mosfet 3 phase full bridge
Top side used Irf 9540 mosfet and bottom side Irf 44n mosfet are used
Here i have used two pots one for tue the circuit and another one vary the speed of motor.
And also test the controller with two types of motors.
#bldc #motor #magnet - วิทยาศาสตร์และเทคโนโลยี
Nice work
Thanks for sharing
Thanks for watching
Very nice sir outstanding work thanks alot
Thanks for watch and supported
Good Work Sir 👏
Thanks
Very nice sir 👌👍
Thanks and welcome
How many watts bldc motor can this circuit drive, im planning to convert motorcycle stator and rotor to 3phase and to make self starter system will this circuit work for it
Great sir💯👍
Thanks for watching and supported
Sir, please see the finished scheme.
Super 👍
Thanks sir
hello, the mosfet not getting hot ?
Nice sir
Thanks for watching and supported
Plz reply will this work on my ebike project and how much volts on which this controller can work
👌❤️👍👏👏👏ईसी प्रकार का dual N channel mosfet का सर्किट बनाए, जी 🙏p channel mosfet ज्यादा कारगर नहीं होते,जब वोल्टेज ज्यादा हो,p ज्यादा गर्म होते है,
Thanks for watch and supporting
Sir, pl send me how make a single phase home made controller
Great work, i have a hoverboard blcd motor 3-phase star connection, i want to built a driver, pls i have a 36v dc battery?
Thanks for watching sir
आपका वीडियो अच्छा है पर P chennal mosfet नही मिल रहे है
Thanks for watching
Irf 9540 mosfet is available in amazon and flipkart
How many volts is the maximum input voltage of the circuit, can you withstand 50v?
Max input supply 24v dc
And i have only 24v dc source unit
@@pugalstech default of motor controller rotates clockwise or counterclockwise, do we have to start it manually? or auto run
It run only one direction because of the sequence of conduction of mosfet.
We connected ist mosfet drain to 2nd mosfet gate thro resistor and 2nd mosfet drain to 3rd msfet gate and viceversa
When we change any motor lead the motor driction was reversed.
If you are properly tuend the drive circuit the motor start automatically and not need any external forces
Thank you
@@pugalstech thank you, currently the controller is a 3 phase motor, if we remove the 2 sets of IRF 9540 and IRF44Z will it be possible to control a single phase motor?
Yes possible, try the project sir
Sir can this controller work on my ebike motor
Low current rating mosfets are used in this controller so it Is not advisable for e-bike applications
I watched the video and made one but it doesn't work
Thanks for watching
If you tune properly it will work definitely
Tune means adjust the pot until the led slightly blink with light sound
Ok.