Hi Mufafa. Very good video. We just fixed the door window for a friend, she is very happy. One tricky part, putting the door cover back, the washer on the threaded stud was not so easy and obvious to us. My friend decided slipping the thin washer into the plastic holder and then getting the door in more or less the right place and pushing/gently hitting it on (just below top speaker as shown in this video). So perhaps there is explanation in Russian, but mine only goes Da and Njet. Other than that, very good help for us. So in the end, we found two issues: 1) after the window was unjammed, by taking the cable gear off the motor (carefully leaving cable drum in the housing), running the motor a few times, checking and lubricating worm wheel and main gear and damper, it worked fine again. The housing for the shaft does look eccentric due to wear though. Some vids show a damaged main gear, but here, not an issue. Some blogs show damaged runners, but did not see any. 2) Switch on driver side was taken a part. We are cheap guys in Holland... Stripped top, then bottom, up to the little circuit board and led light, contacts cleaned (cotton buds) , as well as the actual switch contacts.. They are little disks about 4 mm in diameter with 3 tiny legs. Beware when you put this back together, they fit in different ways where you can get a short...I considered dropping a tiny bit of solder on the worn contacts, but after cleaning with contact spray and getting off the grime (both circuit board and little disks - bottom), it worked again... Open them by using one of these very thin flat clips, they use to put paperwork together, or very thin flat wide screwdriver. Both switch in housing and switch itself have the typical latches seen in electrical kit to hold the bits in place. The switch removes easiest from it's housing itself, if you keep applying pressure from the top and get some space on the long sides to unhook the latches. Put all together, and only had two plastic press-on buttons left / broken, so overall very successful surgery!! ..
Yeah, maybe the clips will be approximately the same locations. But they felt during the surgery where they are. Where there is strength shtupka. May not have the metal bracket above under the mirror. And the screws may be in different locations. But in general the principle is the same. I opened it and other cars is almost an identical procedure. Sorry for the bad English, but I use google translator
does anybody know if the official speaker size and is there a tweeter mounted higher up on the door on the bottom left hand side of the window from the direction the video is filmed?
Във видеото съм написал пояснение, но да кажа и тук. Стоманената щипка не се вади с дърпане към вас както съм показал. А с вдигане на кората нагоре и поклащане ляво дясно. Ужасна грешка от моя страна. Защото така както съм показал се отлепя пласмасата от кората, тази която държи щипката. И се налага да се почисти и залипи добре с Поксипол.
Hi Mufafa.
Very good video. We just fixed the door window for a friend, she is very happy.
One tricky part, putting the door cover back, the washer on the threaded stud was not so easy and obvious to us.
My friend decided slipping the thin washer into the plastic holder and then getting the door in more or less the right place and pushing/gently hitting it on (just below top speaker as shown in this video). So perhaps there is explanation in Russian, but mine only goes Da and Njet. Other than that, very good help for us.
So in the end, we found two issues:
1) after the window was unjammed, by taking the cable gear off the motor (carefully leaving cable drum in the housing), running the motor a few times, checking and lubricating worm wheel and main gear and damper, it worked fine again. The housing for the shaft does look eccentric due to wear though. Some vids show a damaged main gear, but here, not an issue.
Some blogs show damaged runners, but did not see any.
2) Switch on driver side was taken a part. We are cheap guys in Holland...
Stripped top, then bottom, up to the little circuit board and led light, contacts cleaned (cotton buds) , as well as the actual switch contacts.. They are little disks about 4 mm in diameter with 3 tiny legs. Beware when you put this back together, they fit in different ways where you can get a short...I considered dropping a tiny bit of solder on the worn contacts, but after cleaning with contact spray and getting off the grime (both circuit board and little disks - bottom), it worked again...
Open them by using one of these very thin flat clips, they use to put paperwork together, or very thin flat wide screwdriver. Both switch in housing and switch itself have the typical latches seen in electrical kit to hold the bits in place.
The switch removes easiest from it's housing itself, if you keep applying pressure from the top and get some space on the long sides to unhook the latches.
Put all together, and only had two plastic press-on buttons left / broken, so overall very successful surgery!!
..
Браво и Благодаря много! Спести ми доста усилия и главоболия !
I´ve just saved 200€ because of this videos. Thank you very much.
mnogo polezno.BRAVO...
Many thanks! (UK North)
mnogo dobro video brato! bravo :D
Great video, clean instructions!
very nice instructional
you rock! nice work
Very good video. blis montage arier daruoat grand bunto 2008 tankyuo
Thank you!
Please I need the VM Polo 1.4 16v 2000 front door mats with handles. Where can I buy online or chop?
VW Dealer... ebay or alliexpress
Nice👍
@HarrySaunders95 The size of the down speaker is 6.5". Up to the windows have tweeter, size i can't tell you sorry. And sorry for may english :D
thanks!
Te recomiendo un saca tapizados antes de meter un destornillador plano😂 como si fuera un coche robado
super :P
My polo 97 requlator glass should be replaced by a new one. Can I use this method to open the door panel?
Yeah, maybe the clips will be approximately the same locations. But they felt during the surgery where they are. Where there is strength shtupka. May not have the metal bracket above under the mirror. And the screws may be in different locations. But in general the principle is the same. I opened it and other cars is almost an identical procedure. Sorry for the bad English, but I use google translator
Thanks, I could fix my car by the help of your clip!
Gostava de saber se a parte de cima da forra vem de fábrica colada ao plástico branco que está junto ao vidro, obrigado.
does anybody know if the official speaker size and is there a tweeter mounted higher up on the door on the bottom left hand side of the window from the direction the video is filmed?
Não gostei muito da ideia de usar a chave de fendas para desmontar porque marca o plástico
Във видеото съм написал пояснение, но да кажа и тук. Стоманената щипка не се вади с дърпане към вас както съм показал. А с вдигане на кората нагоре и поклащане ляво дясно. Ужасна грешка от моя страна. Защото така както съм показал се отлепя пласмасата от кората, тази която държи щипката. И се налага да се почисти и залипи добре с Поксипол.
Thank you sir!