Houdini Tips - Procedural Bevel - Method 2

A simpler method on how to proceduraly bevel edges using only bevel node with “Ignore Flat Edges” turned on to skip certain edges based on edge angle. This method gives you a little bit less control over beveled edges but is faster and easier.
If you have any comments or question please post them below. Thank you.
Become a patreon and support the channel
/ houdini123
Instagram:
/ houdini123_tutorials

[@stevensilcock]

Nice work but it would be much better for people learning Houdini if you selected more than just 2 nodes. That way we can see how you set up the rest. Otherwise, it can be tricky getting it to work the same. Thanks anyway.

[@Houdini123]

Hi Steve. Ok, next time I can quickly run though the setup. Thanks for the tip!

[@davidtikwa1557]

@@Houdini123 any chance u can go more indepth with this setup im trying to do something with this and kidna hit a wall :)

[@Houdini123]

@@davidtikwa1557 Ok guys. You convinced me :) I will make a new tutorial and show how to set it up. If you are struggling with something specific let me know and I can put it in the tutorial.

[@davidtikwa1557]

@@Houdini123im trying to make it that when 2 objects near eachother and create a flat surface that the chamfer doesnt stick out plus that excessive vertices are welded and the whole mash is clean and ready for bake

[@Houdini123]

@@davidtikwa1557 Ok, I will see what I can do. But the focus will be on procedural bevel. I might tackle other problems you mentioned in a separate tutorial.