They are pretty stable expesaly these ones these are the x factory so if ur bike falls over the handguards will pertect ur grips and ur clutch/brake, cuz it has that bar thing going in the grip.
Hello, I was wondering what happend when the motorcycle falls on the side with the gas handle. Is it possible that the protection slides further into the bar and may block the gas?
Give me some fucking words. I bought these hand guards and I will NEVER buy anything from this company again. They DO NOT fit a Yamaha TW200. A waste of $90.
Jason Barnes ….. Well done. I was at it for what seemed a lifetime and finally cobbled together a solution. I should have sent the bike to you for an install. Lol
Fully drilling the plastic throttle end and moving the throttle over slightly to the left are soooo key!
How stable are these handguards and did they survive long? Nice Video!
They are pretty stable expesaly these ones these are the x factory so if ur bike falls over the handguards will pertect ur grips and ur clutch/brake, cuz it has that bar thing going in the grip.
Not stable break easily
That throttle grip is trapped against the hand guard, that will most definitely hang, I’ll be neatly trimming mine back slightly for good measure.
There are adapters for tapered handlebars to put in the clamps, why haven't you used them...???🤔
Annnnddee I literally don’t have half the tools in this vid to install mine😭😭😭
So is the bar supposed to be even with the levers?
Hello,
I was wondering what happend when the motorcycle falls on the side with the gas handle. Is it possible that the protection slides further into the bar and may block the gas?
No
I’ve got these same handg guards
My throttle doesn’t snap back when I tighten everything down. Any tips?
Unscrew the throttle a little and move it left so you will se end od the handle bar (1-2mm)
Trim the throttle tube
can I instal them on a 22mm handlebar
Yes I think so.
Yes, 22mm is 7/8, standard handlebar size all over the world.
nice!
What size is that step down bit?
Damn this does not work with my pro taper throttle tube
Hello, i'm looking a pair of this handguards for a naked motorcycle. Can You Say me the length of aluminium bar ? Please
How wide do you drill with the step drill? Just enough to fit the expanding end of that bolt? Or further?
2 mm bigger than size of bolt.
Best part of the video was the music! 😂
Sorry you did not like the video.
@@Modelar4ever The videos good. The music could go though. It don't really matter just turn the volume down
@@Modelar4ever I liked the video... Didn't think of the step bit. Going to try it without it first, then see. Seems like a good idea though. Thanks 👍
So many fast-forward..
Give me some fucking words. I bought these hand guards and I will NEVER buy anything from this company again. They DO NOT fit a Yamaha TW200. A waste of $90.
I got them to fit my tw just fine today.
Jason Barnes ….. Well done. I was at it for what seemed a lifetime and finally cobbled together a solution. I should have sent the bike to you for an install. Lol
Bought these for my xt350 and they won't fit right I ordered a different hardware kit hopefully it will work