Elegoo Neptune 4 Max Unboxing and setup | Assembly, Leveling, WI-FI
ฝัง
- เผยแพร่เมื่อ 4 ส.ค. 2024
- Elegoo's newest and largest 3d printer is here, lets unbox it!
Music in video:
Song - Summer
Royalty Free Music: Bensound.com/royalty-free-music
License code: 2NQMQTBMZJL6L3SB
Song - Endless Motion
Music by: Bensound
License code: XPA0YJPWOQKBZWBX
Song - Summer
Music by: Bensound
License code: UGLQ9I2BMPIHNDN4 - แนวปฏิบัติและการใช้ชีวิต
I think one big thing. That you forgot about was the power switch for the United States 115 volt and the 230 volt for other countries.
Yes very true, it usually does come on 230 too so yeah make sure to check that as well! Good catch
thank you! just got mine and I didnt know how to access it from the internet, this is going to be awesome! one thing i ask you, since i´m new: what steps should i follow to make the printer faster and reliable, because I asked it to print in sport mode and it failed. please!
Most of 3D printing is trial and error, unfortunately. You’re going to have to try different settings until you get a successful print. I would say put a raft down as your bed adhesion, enable z hop on the travel setting, and also orient your model so the bed does as little movement as possible
Can you pre heat the bed before doing the automatic 121 point test? It’s a large slab of metal and it takes a while to get evenly heated and for any expansion to have settled down
You can, it won’t to the full 60 usually 40 but yes
Did you update your firmware for the max?
I haven’t yet, it’s been running very well since out of the box, why do you ask
@@CoshTech Because the 4 series from Elegoo has been plagued with problems. If you just ordered yours though, maybe you have a later version of their firmware.
@@Diggiliciousyeah I noticed a lot of issues on the initial release, and I did get mine a little after so you could be right. I did have to tune some settings in fluidd because of some homing issues, but besides that it’s been great.