Had this problem for months. Could never get them to stop coming on even after a couple shop visits. Finally Found out the trailer was the cause. Was sending ABS signals to my truck causing it to trip out and all 4 lights would come on(abs, stability, hill assist, adaptive cruise). Got a new trailer and never seen them since
This happened to me yesterday i had all these lights on dropped my trailer to get it checked all the lights went off then i hook back up yesterday was fine check this morning they’re all back on
Awesome temporary fix.. but problem usually on the cascadia when this happens is the plug to the abs wiring getting wet and needs to be pulled apart and dried.. then reconnected.. it's an issue with these tractors.. suggestions is after drying the connection and reconnect is to protect the connections against water intrusion.
I take it you drive for Hirschbach noticing the Geotab. I drive for them. And my 2022 is in the shop at a dealer in Greensboro NC. Been sitting at a hotel for four days ECAS light comes on all four airbags are flat. and lots of fault codes on my MCM. And the starter block is not cranking over the truck. Lots of issues. Hopefully your 2022 isn't giving you that much problems as mine is.
What works best for me is I shut the truck off turn the battery switch too the off position, turn the battery switch back on and then I’ll cycle the key to the on/off position three times and then start the truck. Works 99% of the time.
Same problem keeps coming back shortly after a few minutes driving in the rain or snow and what makes it worse is that won’t let me switch from neutral to drive unless i reset battery but that’s causing me daily problems
That happened to me too every time it would rain it would go into neutral and would switch into Drive or reverse ended up being some wires that had chafed and with rain they would get wet and short circuit
So, what do you do if the lights come back on? Mine is having the same issue. However will go out just like yours However will come back on with 15 min.
If you idle with your tractor brake pushed in with your trailer brake holding your position & you get an emergency shut down happening & than you go out & check your fluid levels & they are good but than you turn it on & your check engine & regen lights are there & it's not for some reason regenerating you simply keep hitting the override button until she starts her regenerating process & keep over ridding until its done & when it finishes the lights should turn off and you're good to go. Remember that when you're parked for long hours in this heat & trying to save fuel by bringing your rpm to 5 or 6k that soot will build quickly over your filter because the higher rpm isn't cleaning it up as it should. Also lowering rpm by keeping trailer brake engaged on older trucks would prevent oil reaching top of the engine & into your turbo system that in those old trucks would cause extreme damage. It's been 4 years engaging my 2020 to save fuel & she's strong never had an issue but just make sure that she regenerates often
Hey guys….turn da power switch off by the seat….leave it off with the key out the ignition for about 25-30 mins….some times it take more den 5 to 10 mins for it to reset the lights …..thank me later
Daimler Trucks North America, LLC has agreed to recall 218,147 model-year 2017-2023 trucks due to chemical corrosion potentially impacting brake-module operation during the use of adaptive cruise control. According to the National Highway Traffic Safety Administration Part 573 Safety Recall Report 22V-817, “On certain vehicles, chemical corrosion could affect the functionality of the brake-modulator valve, which during an Adaptive Cruise Control (ACC) braking event may result in full system pressure applied to one front wheel end causing brake pull from differential in brake force. Regular service brakes are unaffected.”
It's a wiring harness issue freightliner is aware of it there should be a recall for it. But the harness is on backorder I have been wanting for 7 months and it still is not available at my local dealership.
@@SamC992 they never got my harness in. The lease on the truck ended and the truck went back to freightliner with the same issue. Now it's on the secondary market for sale with 540,000 miles on it. I am in a 2024 freightliner and they seemed to have changed the harness design because they told I will not have that issue with the new truck
Forward facing camera could be the problem if your windshield was replaced and not properly sealed. Water will drip down the plug and cause a malfunction eventually disabling your camera altogether.
Ok fellas, try on the way this guy said , if not help do …. Kill switch off for 5min then turn on , turn your key 3 times(sometimes 6 off n on but don’t start the engine) and should go away, even check engine light if you had a problem then you fixed but you didn’t clear ECM
Hate this stupid crap on my truck, it causes the cruise to not work and I’m governed faster on that OF COURSE. Anytime it rains it happens. Anyway to prevent that piece of crap from getting wet that you know of?
Thank You for going step by step
This literally just happened to me in Chicago
Have a blessed day sir
Must be Chicago weather
Had this problem for months. Could never get them to stop coming on even after a couple shop visits. Finally Found out the trailer was the cause. Was sending ABS signals to my truck causing it to trip out and all 4 lights would come on(abs, stability, hill assist, adaptive cruise). Got a new trailer and never seen them since
This happened to me yesterday i had all these lights on dropped my trailer to get it checked all the lights went off then i hook back up yesterday was fine check this morning they’re all back on
@@williamjohns765same problem. Have u fixed it now?
That’s been my experience also.
Awesome temporary fix.. but problem usually on the cascadia when this happens is the plug to the abs wiring getting wet and needs to be pulled apart and dried.. then reconnected.. it's an issue with these tractors.. suggestions is after drying the connection and reconnect is to protect the connections against water intrusion.
I take it you drive for Hirschbach noticing the Geotab. I drive for them. And my 2022 is in the shop at a dealer in Greensboro NC. Been sitting at a hotel for four days ECAS light comes on all four airbags are flat. and lots of fault codes on my MCM. And the starter block is not cranking over the truck. Lots of issues. Hopefully your 2022 isn't giving you that much problems as mine is.
They'll be back
Your right
😂
For sure, mines been on since February 2023
So guys just got my 2020 Cascadia 2 weeks ago and that shirt keep happening,even service couldn’t find anything,so what’s the main problem??
I can’t find the problem can you tell what is the problem thank you
Had similar problem. Would lite up after hitting bumps. Turned out to be a pin fitment issue with abs module under fuse box on passenger side.
I just got a 22 and it does the same thing! Was it an easy fix?
I have this problem please gave me more details?
What works best for me is I shut the truck off turn the battery switch too the off position, turn the battery switch back on and then I’ll cycle the key to the on/off position three times and then start the truck. Works 99% of the time.
Thank you I did it and it worked 💪
I'm the 1% 😂
Been there.
Done that.
Reset.
Comes back.
I just had this happen to me. Reseting the truck by turning the power off for a few minutes and back on fixed the problem.
What do you do if you don’t have a power switch like that?
@@Mani.bigbank try disconnecting the red and black battery cables for 15 minutes then reconnect. That should work the same way.
Same problem keeps coming back shortly after a few minutes driving in the rain or snow and what makes it worse is that won’t let me switch from neutral to drive unless i reset battery but that’s causing me daily problems
That happened to me too every time it would rain it would go into neutral and would switch into Drive or reverse ended up being some wires that had chafed and with rain they would get wet and short circuit
How did u fix the problem?
So, what do you do if the lights come back on? Mine is having the same issue. However will go out just like yours However will come back on with 15 min.
Just keep repeating the process until it stops
Get it to a dealer or mechanic. The problem keeps happening because there is an issue with one of the 3 systems that are linked together
@@milesintomoney3452🤦🏾♂️😂😂
Thanks for your time I just had some problem and gone Thanks ❤
Was helpful but,if anyone knows what causes this?the root of the problem?
I just got this problem and this method deleted 2 out of the 3 lights. I'm going to do it one more time and pray for the best
If you idle with your tractor brake pushed in with your trailer brake holding your position & you get an emergency shut down happening & than you go out & check your fluid levels & they are good but than you turn it on & your check engine & regen lights are there & it's not for some reason regenerating you simply keep hitting the override button until she starts her regenerating process & keep over ridding until its done & when it finishes the lights should turn off and you're good to go. Remember that when you're parked for long hours in this heat & trying to save fuel by bringing your rpm to 5 or 6k that soot will build quickly over your filter because the higher rpm isn't cleaning it up as it should. Also lowering rpm by keeping trailer brake engaged on older trucks would prevent oil reaching top of the engine & into your turbo system that in those old trucks would cause extreme damage. It's been 4 years engaging my 2020 to save fuel & she's strong never had an issue but just make sure that she regenerates often
That's a Freightliner for ya. But all trucks doesn't matter what model have issues with these damn MCM installed in them.
Once you hit the brake hard it’ll be back on
Thank you. Worked for me.
How do you lower all the beeping noises? They are very loud and very annoying they are a hazard.
Thanks this helped had the same issue 👍
Thank you that was helpful!!!
Hey guys….turn da power switch off by the seat….leave it off with the key out the ignition for about 25-30 mins….some times it take more den 5 to 10 mins for it to reset the lights …..thank me later
Thank you u are the man of the day🎉🎉🎉
Daimler Trucks North America, LLC has agreed to recall 218,147 model-year 2017-2023 trucks due to chemical corrosion potentially impacting brake-module operation during the use of adaptive cruise control.
According to the National Highway Traffic Safety Administration Part 573 Safety Recall Report 22V-817, “On certain vehicles, chemical corrosion could affect the functionality of the brake-modulator valve, which during an Adaptive Cruise Control (ACC) braking event may result in full system pressure applied to one front wheel end causing brake pull from differential in brake force. Regular service brakes are unaffected.”
Mine came on in construction after running on rumble strip, shut the truck off for 15min + and it reset
Thank you
Isn’t the top one HSA (still start assist) the other one is ESC (electronic stability controls ) not traction controll yes there’s a difference!!
It's a wiring harness issue freightliner is aware of it there should be a recall for it. But the harness is on backorder I have been wanting for 7 months and it still is not available at my local dealership.
Just took me 6 weeks to get a driver side steer brake caliper crazy man
@@SamC992 they never got my harness in. The lease on the truck ended and the truck went back to freightliner with the same issue. Now it's on the secondary market for sale with 540,000 miles on it. I am in a 2024 freightliner and they seemed to have changed the harness design because they told I will not have that issue with the new truck
Why are you in reverse while filming
Air breaks are set, I forgot to turn the option to neutral. Semi Trucks don't have parking gear only air breaks
Thanks. It worked.
Work great thank you
Mine doesn’t work I shut it off about 10 mins still come on
Thanks mater
It's happening on my truck I shut it off signs went of and came back on as soon as I started rolling again and it can't shift above 2
Yes helped to me nice
It worked for me
I have the same issue when it rains
Forward facing camera could be the problem if your windshield was replaced and not properly sealed. Water will drip down the plug and cause a malfunction eventually disabling your camera altogether.
Ok fellas, try on the way this guy said , if not help do ….
Kill switch off for 5min then turn on , turn your key 3 times(sometimes 6 off n on but don’t start the engine) and should go away, even check engine light if you had a problem then you fixed but you didn’t clear ECM
Same ,problem ,and skips gears too
Damn your auto shut off comes on hella quick, I've never seen it come on that quick before your company must be really really cheap
I’ve got a 2024 and it does this shit almost every goddamn day Freightliner is garbage
Mines is doing the same thing but, it's stuck in neutral
Something here. Did you fixed it?
I have a semi problem it's CPCA its cost me $5000 IN the dealership
You don’t have spike brake
No
Not working for me lol 😂
Nope mine does it all the time every damn day
Tried didn’t help
Hate this stupid crap on my truck, it causes the cruise to not work and I’m governed faster on that OF COURSE. Anytime it rains it happens. Anyway to prevent that piece of crap from getting wet that you know of?
Or you can get it diagnosed and fixed the right way lol
Freightlined is the worst truck to habe
You didn't fix anything. They come right back on when you start driving again.
Wow, I am sitting in the seat driving and the problem is fixed, but yet a cyber steward won't say otherwise. Interesting
@milesintomoney3452 removing the light bulb would fix it permanently.
😏 ρяσмσѕм
Thank you