Its turning over just not running? I would check through live data and dtc's to see if authorization is missing, may help you understand more of what's going on. Could be isn issue or could be something else unrelated.
I do when I can but my work comes first. Its easier for me to hold the phone vertical then to worry about rotation back and forth or holding it horizontally.
Thank you for these videos. I learn each time I watch.
Good job! Thank you for sharing.
amazing vid thank you very much
Great video this is the best one I’ve seen yet….thanks alot
Thanks for the video
Hey i am currently doing a FEM module, all keys lost, but when i program it, but it does not start up just only goes to ignition on but remote works
Its turning over just not running? I would check through live data and dtc's to see if authorization is missing, may help you understand more of what's going on. Could be isn issue or could be something else unrelated.
@@ecurepair Called Autel they told me to clear the code and sync DME, then it started up, thank you!!!
Did you get the ISN code via obd 2 or bench
I had backed up on bench first, but I was able to do it through obd2 ok.
What chip you use for it pcf7953 or pcf7945?
I believe it was 53
👍👍👍🔥🔥🔥👍👍👍👍👍
Great video. I think Autohex could have made this job simpler than autel did.
Unfortunately that's a tool I do not have. The bench tool for the FEM helps a lot. I need to found out where I put it before the next one.
Nice video, but turn the camera 90 degrees - say no to vertical videos.....
I do when I can but my work comes first. Its easier for me to hold the phone vertical then to worry about rotation back and forth or holding it horizontally.