UNDER VOLTAGE SHUTDOWN POSSIBLE CAUSES OF THE PROBLEM? part1

[@jubsofficialvlog1473]

Watching lods.

[@benzblogsVlogs]

Thank you

[@jubsofficialvlog1473]

Nice one idol iba talaga Ang may alam

[@benzblogsVlogs]

Ikaw din lods galing modin

[@elporky6420]

Do you need to adjust AVR on DSE config suite 8610 mk2, I always adjust centre and range? Can you do a video showing that? Please

[@benzblogsVlogs]

Yes if nessisary you need to catch 70-75 percent of a calibration

[@elporky6420]

@ I've tried but can't always get to 70-75, if I change one, it takes the other one off track, any way you could please make a video like that?

[@elporky6420]

@ I use AVR ss341, 440s, and 408

[@benzblogsVlogs]

@@elporky6420 sw1-2 in 75% thin andjust the avr according to you needs

[@LoveBone-b1d]

how you sense the output voltage on AVR if you remove U & W cable

[@benzblogsVlogs]

In order to undertand what are the posible causes of low voltage shutdown

[@ObinnaEmmanuel-k4f]

Good afternoon sir I want to know how to use laptop for troubleshooting for generator

[@benzblogsVlogs]

Sir simple just connect open your sofeware and go to scada there you can see all the digital input and ouput if active or not active what are the alarms

[@hermantoofa1868]

Hi bro
What about overvoltage?what is the different causes ?

[@benzblogsVlogs]

Over voltage only happen if you have shockload or defective avr both under over

[@benzblogsVlogs]

You can check in my vedio all have

[@hermantoofa1868]

@@benzblogsVlogs i have overvoltage when no load , i check my avr, weeding of alternator and stator exctitatrice is good

[@benzblogsVlogs]

Thin first thing you have to adjust the avr to the voltage u need make sure your configuration is correct to which you need to follow that while your adjuat your nominal voltage after that put delay for over and under voltage

[@MbwanaAli-y1i]

Oh long time i cant se you good work

[@benzblogsVlogs]

Thank you

[@JohnPaulDorado]

Gud eve Sir Benz ano pa kaya sira Ng generator no frequency alarm .tapos busted Ang mga diode ano kaya pwede dahilan salamat😊😊

[@benzblogsVlogs]

Over excitation cause that problems

[@shahshibly-en5uo]

Worst vedio quality

[@benzblogsVlogs]

Thank you

[@MalvinFernandez-z5g]

Ikaw lang ang nag gawgawa ng trouble mo 😅😅

[@benzblogsVlogs]

Oh thank you so much may Godbless you