OD turning with an endmill in a boring head.

[@southerningenuity4458]

Very cool. I had to use an end mill in my boring head too one time. I thought I was the only one.

[@ellieprice3396]

Good job exactly the way I would have done it. Of course you could have used a boring bar but the end mill was a nice change. You obviously needed a different fitting from stock. Nice welding job also.

[@josephcrowshaw950]

Creative use of the countersink tool. I have to say, those parallels sticking up a bit would’ve made me jumpy.

[@avijitDrilling92]

👍

[@bobengelhardt856]

Bottom line is that you cut off the threaded part. Which could have been done on a bandsaw. But without the chamfer.

[@peterhalstead7281]

This was already set up before you made the vidio

[@franksfabmachine7448]

@@peterhalstead7281 Ya I did the other end first.