Could you spray weld it with oxy-acetylene and metal powder? What are the pros, cons in that repair? What are the specs (more info) on that cobalt hardfacing rod?
Hello, I know you don't answer anyone, but I'm going to try hahaha, what kind of contribution do you have to give to weld cast iron? After welding you have to cool down, do you have to give some heat treatment? I'm from Spain, so don't worry, I'm not going to take the job away. Thank you very much, you are a genius.
How much to weld & resurface one lobe on 1986 BMW 735i (E23)? What a piece of a junk car this is. Less than 51K & always serviced by BMW up to 51K. Now, sat for 20 years.
How does that heat on one side not warp the cam? (like torch straightening etc) do you clean up the bearing surfaces some how?
Interesting. Is the journal-journal run-out unaffected by this process?
Could you spray weld it with oxy-acetylene and metal powder? What are the pros, cons in that repair? What are the specs (more info) on that cobalt hardfacing rod?
Nice, I like what you guys do.
Can this process be used to increase lift on a flat tappet lifter cam for an older v8 engine?
Yes but not cost effective
What kind of filler material do you use for that?
Hard facing rod I suppose
Can you guys resurface a pair of harley flathead cams for me??????????,,Im sure the setup for that is far different but is it posible???
if you could please send photos in an email to our website I can review them and reply to you there
deltacam.com
how bad is run out after all that heat?
Does that give you more lift also?
Hello, I know you don't answer anyone, but I'm going to try hahaha, what kind of contribution do you have to give to weld cast iron? After welding you have to cool down, do you have to give some heat treatment? I'm from Spain, so don't worry, I'm not going to take the job away.
Thank you very much, you are a genius.
Did you find out ?
Doesn't the Camshaft Have to be Heat treated again, after reground
Those cams a not heat treated, they are chill cast
سلام اريد التواصل معك لو سمحت
Can we do it on bmw e36 m52 cam shaft? I need hight duration for race car
what shielding gas mix do you use?
Can you regrind a Wisconsin V465D cam?
It is an industrial air cooled V4 motor
Yes sir
@@DELTACAM8005625500 Thanks for the fast reply. I’ll get with you Monday. Have a marry Christmas!
I imagine that you first grind the lobes undersized before facing?
Me to
Rod is colbalt ?
It's very good
What filler is that.
Hello James, I know this response is a bit late (!), but I rekon the rod is Cobalt 6 (sometimes called Stellite 6).
How much to weld & resurface one lobe on 1986 BMW 735i (E23)?
What a piece of a junk car this is. Less than 51K & always serviced by BMW up to 51K. Now, sat for 20 years.