Was looking for this for forever. With the the 3 position switch on the rough country light bars didn’t want to lose anything hooking it to my switch. Thanks so much
Hey sorry for the delay. There are sets of wires for each. 2 Blue, 2 White and 2 black. Black in negitive, the Blue and white are the high and low beam (forget which is which)
Was looking for this for forever. With the the 3 position switch on the rough country light bars didn’t want to lose anything hooking it to my switch. Thanks so much
Thanks for the comment and glad you found it useful!!
Very helpful. Thank you
Thanks for the feedback
If you only want high beam can you just tape the low beam and be ok
I would think so but not sure. I would call RC to ask them. They were very helpful when I needed info on what wire did what.
As far as the low and high beam wires is there an indication on which one is positive and which is negative?
Hey sorry for the delay. There are sets of wires for each. 2 Blue, 2 White and 2 black. Black in negitive, the Blue and white are the high and low beam (forget which is which)
Did you remove the relay or use it?
It’s been a while since I did this. Pretty sure I removed it or there wasn’t one.