Full LED Upgrade Kit! | Superior Vision Australia | Ford Ranger Mods
ฝัง
- เผยแพร่เมื่อ 30 ก.ย. 2024
- I can barely see on country roads, time for an UPGRADE!
This kit comes with all the white light LED's you're ever gonna need!
Check out Superior Vision Australia at the link below:
www.superiorvi...
THIS IS NOT A SPONSORED VIDEO
Check out Shenanigans4x4 Merch!
www.bonfire.co...
Follow me on:
Facebook: / shenanigans4x4
Instagram: / shenanigans4x4
Music:
freemusicarchi...
Crowander - Flash
www.bensound.c...
Actionable
#shenanigans4x4 #superiorvisionaustralia #4wd
Did the rear lights work with upgraded taillights?
Your starter battery sounds like it might need a replacement as well! I did the same upgrade on my PX1 XL last week too. What a difference, can actually see where I am going now.
I know right! How awesome are they?
I think you might be right about the battery, been like that since I installed my winch.
I now have the winch physically disconnected but the battery never bounced back.
@@Shenanigans4x4 I also dipped my drivers side quite a bit as well. They are awesome, as to be honest the original lights were quite dangerous away from the street lights etc.
Did you readjust headlights at all.
I haven't adjusted mine but haven't had anyone flashing me either
How do you find them longevity wise ? They still going strong ? Tossing up between these or the STEDI ones
Hey mate
Honestly over a year on and they're still going strong 👍
STEDI do have a good rep, but I definitely recommend Superior Vision
Cheers for watching 🍻
Me too
Great video mate, I’ll have to get a kit for my ranger.
Cheers Blake👍
Definitely recommend them!
I did an upgrade in mine. I had to reset the BCM first and put a canbus in on both lights so i could get low beam
This kit comes with the canbus built in, so it is just plug and play
Cheers for watching 👍
Hey mate! I had put Canbus built-in LEDs in my Ranger and I couldn't get Low beam either. Swapped back to halogen bulbs and still have no low beam in one headlight. I am confused! What was your experience exactly?
Hey Jonathon, mine just worked out of the box
Have you tried getting the BCM reset like Roger?
I have a PX1 Ranger if that makes a difference
@@Shenanigans4x4 I will have to book in the BCM reset. Is that a Ford only issue?
Did you unplug the battery during install of the front lights? I'm going to do my lights tomorrow, and was told to remove battery first...
I didn't disconnect mine but you can never be too safe mate, just disconnect the negative terminal put a price of plastic or cardboard over it so it doesn't connect accidentally
Cheers for watching 👍
@@Shenanigans4x4 cheers mate. What did you buy for the headlights! I'm headed out today to buy some
I got a kit from Superior Vision Australia, link in the description
Hi do you get lines on the screen for the reverse camera?
Nah mate, might be a setting on the rear vision screen that was in the car when I got it.
I have 2 rear cameras and I suppose they may both be connected but the previous owner didn't leave the manual to it with the car