Thanks for the video - I wondered about something though: The catch can/filters run parallel to the ground. I would have thought you'd want those perpendicular. That is, the hose at the top can the can at the bottom. Seems that gravity would then assist with dropping oil into the can...?
You don't want your bypass filter up that high, it will spray out oily mist. I had mine right under the air filter between the push rods and it got all over my pipes. Although that is way better than going back into the engine you should think about routing the lines down low under the engine to the bottom of the frame.
What did you do to the stock backing plate where the breather bolts rubber tubes got removed? It would appear that there’s a good gap between the filter and the backing plate along that track in those channels that the stock rubber hoses ran.
Thanks for the video - I wondered about something though: The catch can/filters run parallel to the ground. I would have thought you'd want those perpendicular. That is, the hose at the top can the can at the bottom. Seems that gravity would then assist with dropping oil into the can...?
You should also put a one-way check valve on your vent line so Eric can go out not in
You don't want your bypass filter up that high, it will spray out oily mist. I had mine right under the air filter between the push rods and it got all over my pipes. Although that is way better than going back into the engine you should think about routing the lines down low under the engine to the bottom of the frame.
100% rite, I re routed it down lower under the bike
Don't need a filter. Just route it down to the ground.
You should check out T-Man’s video on how he directs those to the transmission pad
Was thinking to do that but this was just much more simple and easier
🤙🤙🤙
What did you do to the stock backing plate where the breather bolts rubber tubes got removed? It would appear that there’s a good gap between the filter and the backing plate along that track in those channels that the stock rubber hoses ran.
The gap is very small, didn't block them off or anything, might just put piece of rubber 2 seal it off
❤❤❤