Repair STUCK RV Step - Kwikee Motor Replacement

Are your RV steps stuck or making a terrible noise? In this video I'll show you how to test the components of your Kwikee RV step and replace the step motor. Also see my other video "How to replace the gear linkage" (Link below).
KWIKEE / LIPPERT AUTOMATIC RV STEP REPLACEMENT PARTS
www.rvwithtito...
(VIDEO) HOW TO REPLACE THE GEAR LINKAGE in KWIKEE RV STEP
• EASY RV STEP REPAIR - ...
KWIKEE STEP OWNERS AND TECHNICAL MANUALS FROM LIPPERT
support.lci1.c...
STEEL FIREPIT FEATURED IN VIDEO
Kettle Creek Grillware Portable Firepit (Handcrafted in USA) www.kettlecreek...
MORE ABOUT THIS EPISODE
If your RV step fails to operate, the cause will either be an electrical or wiring problem or a mechanical problem.
Locate the four pin connector that powers the step. Follow the procedures outlined in the Lippert Owner’s Manual for testing the power output (red wire) and switch control voltages (other 3 wires) from the magnetic door switch, override switch and ignition switch.
If the four way connector test passes, then your RV is supplying the necessary power and the switches controlling the step are functioning properly.
Next check the output from the control unit to the step motor. If the step does not expand or retract, then disconnect the switch to the motor and check the positive and negative wires for a 12V signal when the step is triggered. If the step motor is getting power, but not operational, then the motor is likely faulty and needs to be replaced.
If the motor makes loud noises when operational, then replace the motor.
It is unlikely that the gear assembly and control unit will go bad. But follow the testing procedures outlined in the manual if you suspect a problem with those units.
Replacing The Motor
1. Disconnect power to the step
2. Disconnect the power plug from the motor assembly
3. Using a 10mm socket, remove the 3 screws holding the motor assembly
4. Lower it straight down being certain not to drop the gear, washers and pin on the gear assembly side of the motor
5. Move the washers, gear and pin to the new motor
6. Apply new grease to the gear if needed
7. Insert motor assembly into gear box and insert the three screws
8. Tighten the screws down with a 10mm socket
9. Reconnect power plug to the motor assembly
10. Reconnect main step power (four way connector) while staying clear of moving parts
11. Test Step operation
#rvwithtito #rvdiy
DISCLAIMER
The opinions expressed in our videos are our own or from a contributor. Before taking on any project or making a large purchase, we recommend you do your own research and consult a professional for advice. We are NOT liable for any damage to your RV or injury incurred as a result of following our tips, advice or instructions. We are not RV professionals or certified technicians. We are simply RV owners who work on our own RVs and have a desire to share what we learn with others. Be responsible and know your limits.
AFFILIATE DISCLAIMER
This video may include links to merchants with affilliate programs who pay us a commission on purchases made or actions taken after clicking the link. We are a participant in the Amazon Services LLC Associates Program. As an Amazon Associate we earn from qualifying purchases.