Everytime I turn on the amp for the first time, it comes sound 'duk' at speaker, when I turn off and turn on again, the sound is disappeared, what is the problem ? can you give me any suggestion
Sir may transformer ako Ng peavey 2600,bkt Kya Wala ako m read n volts s secondary,lht Ng wire tinest ko Walang reading,pero pag hndi nkasaksak s 220volts meron nmn sya continuity?paano b I test ito sir?salamat
May I ask you, I have same pv2600, when i open volume full, there is any noise at channel B but channel A is clean, can you give me the clue what is the problem ?
you remove four signal diodes at the input of the buffer, it is connected from the signal input towards the supply for both + and - rails...... same thing happen with one of my repaired peavey amp...
I tried to dismantle input board, the noise disappeared, but when i connected nut of input lo/hi z, noise came up again, means - terminal cannot touch ground body, what wrong with this ? Any component fail ? Thanks for your respon
Yown! 💯.. Iba tlaga pgka my experience.. Salamat sa tips master
welcome po
eliminando quei 4 diodi ritorna a funzionare ? non ne a bisogno ? ( by eliminating those 4 diodes does it work again? don't you need it? ) italy
Everytime I turn on the amp for the first time, it comes sound 'duk' at speaker, when I turn off and turn on again, the sound is disappeared, what is the problem ? can you give me any suggestion
Sir may transformer ako Ng peavey 2600,bkt Kya Wala ako m read n volts s secondary,lht Ng wire tinest ko Walang reading,pero pag hndi nkasaksak s 220volts meron nmn sya continuity?paano b I test ito sir?salamat
San po location nyo?? Pagawa ko sana pv2600 ko .wala tunog ung isang channel
San po shop nyo pwede po ba mag pagawa ng peavey gps 2600
May I ask you, I have same pv2600, when i open volume full, there is any noise at channel B but channel A is clean, can you give me the clue what is the problem ?
you remove four signal diodes at the input of the buffer, it is connected from the signal input towards the supply for both + and - rails...... same thing happen with one of my repaired peavey amp...
I tried to dismantle input board, the noise disappeared, but when i connected nut of input lo/hi z, noise came up again, means - terminal cannot touch ground body, what wrong with this ? Any component fail ? Thanks for your respon
please do remove the signal diode that i mention it will iliminate the noise
@@fidodidotech2789 thank for your suggestion 👍
One more question, when i turn on the PA, sometimes it sounds jeduk, sometimes doesnt, what is the problem to this pv2600 ? It can damage speaker
boss meron ako parehas nyan kaya crest cpx2600 nmn sya sira din ung channel B nya boss
Done subscribe master... Nakit, an raku Tika kadugayan dri hehe
hehehe salamat
Sayang pv 2000 ko Napa timbang lng