MERCEDES C CLASS W204 C350 NO START NO CRANK NO COMMUNICATION WITH TRANSMISSION NO SHIFTER
ฝัง
- เผยแพร่เมื่อ 6 ก.ค. 2023
- MERCEDES C CLASS W204 C350 NO START/CRANK NO COMMUNICATION WITH TRANSMISSION NOR SHIFTER 2008 09 10 11 12 13 14 15
THANKS FOR WATCHING! PLEASE LIKE AND SUBSCRIBE 😊😊😊
![[LIVE] : ONE ลุมพินี 72 | คู่เอก "ก้องศึก vs โจอาคิม"](http://i.ytimg.com/vi/hT1EOSsRPac/mqdefault.jpg)
My glk 350 2013 has the same problem it won't crank and has the "do not shift gear and vehicle not in park" error. there were previous repairs on the driver's side can buses area. I noticed there was water on the floor carpet and dried it all out. Now the car starts but the break lights are on and the back lights won't go off.
There are orange and white socket in the same place with the can buses areas the orange socket seems to have some repairs. My question is it safe to by pass those sockets and correct the wires directly because I noticed there are some already bypassed wires there
You shouldn't have any wires that have been bypassed! All wires must be connected properly to these connectors and all wires should be free of rust or anything similar! If you see repairs you must make sure that the wires were repaired properly and that they actually work! As far as stuff happening on the rear you can also check your Rear Sam for problems there because the electronics in the Rear Sam are responsible for those Rear lights. I hope I have helped you so far and if you need more help don't hesitate to contact me again. Thanks and Good Luck! 🤞💪👍
What’s causing the flooding ??? I’m having the same issue. Also can the carpet be pulled up without removing the seats ?
Either there's a leak from you air conditioner inside the dashboard or there's a leak from the drain tubes of the sunroof going through the A Pillars. You have to investigate it technically... I believe you could put part of the carpet without removing the seats but this carpet is very thick and hard to pull... You just need to try and see how far you can get... Thanks 👍
Can a bad can bus stop the c300 2008 from upshifting, changing gears? Please help out
It could or course but you still a proper diagnostic so you can see what error codes you have in the system. Unless you actually have a problem with your transmission and this has nothing to do with the Canbus system. Thanks and Good Luck! 🤞💪👍
I had the "mercedes" crossfire with the power seats problem. They used crap solder in the whole car including relays. Found the seats relay under dashboard and resoldered loose pins inside and now they work.
💯💪👍
What’s the part number for the ground connector ? My local dealership can’t find it for my w204 c300
Try to call another dealer because they know about these ground connectors and they should be able to tell you which ones your car needs! I already installed these on the vehicle and that vehicle has been gone for months. Plus I cannot guarantee that whatever I tell you will actually fit your car so this is why the Dealer needs to give you the correct parts for your car... Thanks 👍
I have a 2010 c350 and I scanned it and it gave me 5 codes u0101 p0607 p0455 p0306 and p0300 do you think it could be the connectors possibly
Normally you have to investigate the codes individually or sometimes altogether if you are an experienced mechanic and you would know what these codes with me when they show up together. These connectors will give you problems only if they are rusted so you need to get to them and check them thoroughly and see if you see any rust or any other problems. If they're clean then most likely this is not your problem. Thanks and Good Luck! 🤞💪👍
Hola como va como se llaman esos conectores xq me paso lo mismo y nececito comprarlos
These are called ground connectors. You can call your local Mercedes dealer to ask for them and see what numbers you need so you can order the correct ones... Thanks 👍
I'm having the same issue,I already changed all the connectors and it still won't start, I also checked fuses 16 and 31 and they are fine, what else can I do, at the end of the video you were left without connection between the transmission and the computer again, what was the problem really
Additionally to these Canbus connectors we ended replacing the EIS to fix the car. Every repair would have their own individual twist and resolution so these videos I make are only guides to what you can try on your own. If you have no access to a professional scanner to also check the communication between the computers in the vehicle, you are going to need to go to a professional mechanical shop that deals with German vehicles so that they can diagnose your car completely. Thanks and Good Luck 💪👍
Hi mate
I have same issue
I have eqc 2021 model
Same water ( little bit to the driver side )
Car no start no power
Only thing works is the wiper moves by it self
Interior lights works , and hazard light works
But my key fob doesn’t lock or unlock and no ignition no power
Wouod it be these connections under the seat ?
I checked fuses
Checked rear fuses they seems okay
You can try by replacing these for sure! These are CANBUS and other connections so you need to try these first... Thanks and Good Luck! 🤞💪👍
@@projectathos
Great
Thank u mate ,
I saw a way to test them so I’ll see
Anything else to try please ? If it didn’t work
Next step I would do is find a Professional Scanner or pay a shop do get a proper diagnostic with that same scanner to see what modules are complaining and for what reason. Thanks 👍
@@projectathos yeah agree mate
Will try that
Mine is giving me an inoperative see owners manual message and just wont crank.
You need to find a shop that can scan your car's computers and start diagnosing your problems... Thanks 👍
Mines days the same thing I had it diagnosed it said no communication to front sam. Mercedes suggested changing the connector
Mine does the same I suspect it was water because it'll act up after rain, it doesn't have communication with gearbox sometimes it turns on and doesn't let me shift sometime it turns on and runs fine but after a while it stops wanting to shift and if I turn it off I can't turn it back on do you think it can also be the issue you fixed?
Possibly it may be because your symptoms sound very similar to what this car we repaired was doing. Anyway it will not hurt for you to check if there's water accumulating under the carpet so you can take the appropriate steps to repair the cause of the problem and if you need to change these ground connectors. Let me know if you have other questions! Thanks and Good Luck 🤞!
@@projectathosactually last night I removed carpet and sure enough there was plenty of water on passenger side both connectors had a lot of corrosion earlier I picked them up from the dealer and will replace them later today hopefully that fixes it
@@projectathosactually last night I removed carpet and sure enough there was plenty of water on passenger side both connectors had a lot of corrosion earlier I picked them up from the dealer and will replace them later today hopefully that fixes it
@@rektdgaming356 Lmk how that goes, im running into the same problem, and I cant even drive. Keep me updated
@TheRealDealish this fixed my issue, mine were the 2 passenger side, replace them they cost me 15 bucks each at dealer you can also order online. also thanks to @projectathos
I'm having the same problem, what's the part # ?
You need to call your local Mercedes Dealer to inquire exactly what parts come on your car and what their part numbers are. You could also purchase them from the Dealer is what I would recommend... Thanks 🤞👍
Wtf are those called so I can order those same as you have?
They are Ground Connectors I believe. Call the Dealer explain where they are located and what they look like and they will know! Thanks 👍