ขนาดวิดีโอ: 1280 X 720853 X 480640 X 360
แสดงแผงควบคุมโปรแกรมเล่น
เล่นอัตโนมัติ
เล่นใหม่
2 strong magnets on those disks to pull square. Not sure if that would work but a idea
How about some mineral spirits, at least it won't rust and it'll degrease it
I don’t like to see you have problems, but I do like to see how you fix things.Thanks for the video!
@@charlesjenkins8078 I don’t like problems either, but the challenge is always fun….most of the time! LOL
Andy, I’m no expert but I was thinking. If you wash it out one more time with Royal Purple can you dry the clutch disc with some sort of heat. I thought that they could soak up moisture.
Try some lady slippers pry bars ,works on the Oliver's
Are you going to replace the brake cylinders on this tractor, if so where you did get new ones. My brothers A4T-1400 needs them replaced.
@@jim-normawuertz2628 I am replacing them. I will show the cylinders in an upcoming video
So Andy, you were turning the A4T engine over to build oil preasure. Was that a procedure they called to do before you actually started the engine.
@@millardhayes1884 just something I do. Figure getting the oil flowing is a good thing…..but I could be wrong
@andyohiomm5364 I could see doing this to get the oil to needed areas quicker.
2 strong magnets on those disks to pull square.
Not sure if that would work but a idea
How about some mineral spirits, at least it won't rust and it'll degrease it
I don’t like to see you have problems, but I do like to see how you fix things.Thanks for the video!
@@charlesjenkins8078 I don’t like problems either, but the challenge is always fun….most of the time! LOL
Andy, I’m no expert but I was thinking. If you wash it out one more time with Royal Purple can you dry the clutch disc with some sort of heat. I thought that they could soak up moisture.
Try some lady slippers pry bars ,works on the Oliver's
Are you going to replace the brake cylinders on this tractor, if so where you did get new ones. My brothers A4T-1400 needs them replaced.
@@jim-normawuertz2628 I am replacing them. I will show the cylinders in an upcoming video
So Andy, you were turning the A4T engine over to build oil preasure. Was that a procedure they called to do before you actually started the engine.
@@millardhayes1884 just something I do. Figure getting the oil flowing is a good thing…..but I could be wrong
@andyohiomm5364 I could see doing this to get the oil to needed areas quicker.