Some new things. Mazda B2600i part 1

แชร์
ฝัง
  • เผยแพร่เมื่อ 18 ธ.ค. 2024

ความคิดเห็น •

  • @oldchevy4x4
    @oldchevy4x4 11 ปีที่แล้ว +1

    Nice project! You can't beat those little 4cyl 4x4's.
    Good luck!

  • @redfoxmountain
    @redfoxmountain 4 ปีที่แล้ว +1

    I have a 1991 Mazda B2600i 2.6L 4cy. 5spd man.
    The exhaust manifold is cracked at the bottom where it connects to the exhaust pipe.
    I'm in need of a replacement exhaust manifold.

  • @roykelly5486
    @roykelly5486 5 ปีที่แล้ว +1

    thanks for sharing, I have a 91 b2600 4x4 5speed, I am looking for a rear pinion 4.30 ratio :) eh

  • @wrencharoundandfindout8780
    @wrencharoundandfindout8780 4 ปีที่แล้ว +1

    That's how it works if you lose a key you must bust the ignition because 100% guarantee you'll find it shortly after

  • @thegreatwhitenorth8754
    @thegreatwhitenorth8754 7 ปีที่แล้ว +1

    They usually overheat cause the fan clutch stops working properly, then when you sit in traffic it slowly climbs up in temperature then by the time you notice the head warps and the head gasket blows. So dont forget to buy a new fan clutch

  • @bryang2724
    @bryang2724 7 ปีที่แล้ว +1

    I got a 93 b2600i that's fairly clean, I just changed the valve cover gasket but checked the valves while it was off and didn't notice any play at all.

  • @rockyjohnson7227
    @rockyjohnson7227 7 ปีที่แล้ว +1

    I have a 91 mazda B2600i 2wheel drive Auto great little pickup! Anyway all of a sudden it just quit like it ran out of gas but left it set 15 minutes started up? Long story short I was told that i needed Mass Air Flow got one put it in and does same thing it runs well down hyway then it just quits let it set and styarts up and runs using alot of gas!! Pull the computor brain box took cover off and there was a diod burnt!! So i need a new brain box once i get one and put it in do you have to reset it or do anything??? I am not a certified mech. and the nearest mechanic that works on foriegn vehicles 300 miles away! So any advise

    • @robert281979
      @robert281979  7 ปีที่แล้ว

      I am not a certified mechanic either, but I am going to say no. You should not need to reset any thing. It should just be "plug and play". I did end up getting rid of the truck, long story.

    • @thegreatwhitenorth8754
      @thegreatwhitenorth8754 7 ปีที่แล้ว +1

      Your problem is the ecu forsure. Get one from a wrecking yard or try craigslist. Even ebay. But it definetly is the issue. And nope. Unplug the battery, change the ecu, then hook the battery back up and your good to go. Ive had 6 of these trucks, been through the exact same thing with my 2nd one.Had my ecu rebuilt, not knowing it wasnt done right. So i spent $1200 on parts and it still wouldnt start.. Then i found another ecu at the wrecker, plugged it in, and my truck fired right up. So just change the ecu and you'll be fine

  • @shanestephens4572
    @shanestephens4572 3 ปีที่แล้ว

    I have a 92 b26001 2wd It is hard to crank if it does you mash gas it will bog down and die it will idle good for about 5 minutes then just dies any suggestions thanks

    • @robert281979
      @robert281979  3 ปีที่แล้ว

      Shane Stephen's, that sounds like a fuel issue.

    • @shanestephens4572
      @shanestephens4572 3 ปีที่แล้ว

      @@robert281979 i replacedfuel.pump and filter where the line goes to the fuel rail there is a part looks like a pressure regulator then on end of rail is the pressure regulator whats the first one and what would you recommend now thanks

    • @robert281979
      @robert281979  3 ปีที่แล้ว

      Make sure your still getting fuel when it dies. Other issue is could be having, is its loosing spark or lack of spark. Check or replace spark plugs. Process of elimination. Computer could very much be an issue, or a crank or cam sensor as well.

  • @nateb6781
    @nateb6781 4 ปีที่แล้ว +1

    Did you finish it

    • @robert281979
      @robert281979  4 ปีที่แล้ว

      No, ended up selling it and got a bigger truck.

  • @marioorona7506
    @marioorona7506 3 ปีที่แล้ว +1

    1991 Mazda pu.