I found out that the dots won't match up for over 100 revolutions. Thanks for your help and thank you for making this video. Greatly appreciate the time you took to do it.
You didn't show how you remove the crankshaft and how you install the crankshaft I don't want to see the broken pliers and digging in the oil bucket looking for bolts !!!
Did you put any pre lube in the oil pump? Oil pumps don't work dry, the lube seals everything up and creates the vacuum needed to draw the motor oil up to the pump, after that you have pressure.
Can you lube the oil pump after it is installed (I already have the gear cover on)? I heard you can send oil down the censor and fill up the oil filter then turn the engine, not sure though?
@@jamesrombach4884 On the oil pressure switch hole, you can fill the oil system and than you wont let your engine run dry, also the oil pump will get filled.
Do you remember where you bought the manual you are using? TIA, Dave.
Ebay "bobcat 743 manual" they're $16-$50
that engine will have a good amount of power once your done
I sure hope so. I hope I'm doing it right. I've never done an engine before
Mister klu manual shopnya bisa covy mister?
I put all the gears on there Mark's, but after I spin the crankshaft I can't get them to line up again. I am doing something wrong?
Once you put them on their marks, they won't line up again for 2 more revolutions......I think.
@@fitzsfixes that's what's confusing, they won't line up no matter how many revaluations I make.
I found out that the dots won't match up for over 100 revolutions. Thanks for your help and thank you for making this video. Greatly appreciate the time you took to do it.
You didn't show how you remove the crankshaft and how you install the crankshaft I don't want to see the broken pliers and digging in the oil bucket looking for bolts !!!
great job
Did you put any pre lube in the oil pump? Oil pumps don't work dry, the lube seals everything up and creates the vacuum needed to draw the motor oil up to the pump, after that you have pressure.
No I didn't. I'll take it off and lube before I go any further. Thank you for that!
Can you lube the oil pump after it is installed (I already have the gear cover on)? I heard you can send oil down the censor and fill up the oil filter then turn the engine, not sure though?
@@jamesrombach4884 On the oil pressure switch hole, you can fill the oil system and than you wont let your engine run dry, also the oil pump will get filled.