ฝัง
- เผยแพร่เมื่อ 26 ก.ค. 2024
- Part 1 of a 3 part video series covering the Trail Tech Vapor gauge. This part goes over what the Vapor does and what is typically required to use one. Most of the details are focused on scooters, but much of the info is applicable to many platforms.
Part 2 Installation : • Trail Tech Vapor Gauge...
Part 3 Setup : • Trail Tech Vapor Gauge...
Thanks for watching!
Please Like, Share, Favorite, and Subscribe for more!
#TrailTech #Vapor #InstrumentCluster
I am in no way affiliated or associated with Trail Tech. These videos were made because I get a lot of questions about this gauge in the comments sections of multiple videos where it is seen. Trail Tech was kind enough to let me use some of their stock photos of their parts for my videos. - ยานยนต์และพาหนะ
Great video! Really helpful if your thinking about buying one! Nice to see some fresh content on your channel!
Thanks Alex!
Awesome. Will be installing this on my moped.
Great video! Ty!
Thank you.
Great video! On the trail tech website I couldn't find any speedometer for my bike yamaha tt600r 2003 which hasn't battery and electric start.. can any of these products work for me?
I have never tried it, but they are supposed to work with AC power. One manual says 6-400VAC. Check this out :
www.trailtech.net/media/wysiwyg/pdf/010-ELV-07.pdf
90GTVert Thank you very much!
Do you take the spark plug ring off when you put the temp ring on? I was told to that on my 2 stroke but not sure about 4 stroke, and are temp ranges same as 2 stroke?
I remove the crush washer on the plug so the plug sits at about the same depth as before when using the under plug sensor. Temp range is similar.
Hi ...please this vapor shows a mth ?
Not sure what a MTH is. If you meant MPH, then yes it can display MPH or km/h.
it is compatible for any motorcycle?
It is a "universal" product. With the right sensors, it should be able to work on a lot of different applications.
@@49ccscoot how about for fi engine type? i bought china type digital odometer but the rpm doesn't accurate.
@@crisimplefitness522 If you tie it into a coil + lead, it should work. It can be adjusted for different pulses per revolution as well. 0.5, 1, or 2.
@@49ccscoot i just tie wire of the rpm to the enginsion coil. but the signal of rpm is to low..
@@crisimplefitness522 You probably need to change the pulses per revolution setting to correct it.