Love the video. It might be better if you could add links to the parts you purchased to the description below the video. Thanks for sharing, Sincerely .................
Very informative video, watched lots of others to try change my fuel pump before coming across this, the others didn’t mention the little o-ring at the top of the fuel pump I ended up having to take bike to shop that was the problem wished I had watched this video. Can I make a suggestion you put in a tutorial about getting that little green clip off on the outlet hose, I struggled for ages trying to work that out... otherwise great video
Would’ve been a much better video if you would’ve showed how you remove the fuel pump and what all that entails for people that don’t know how like me. Thank you for your videos can you help would be appreciated. Thank you.
I was able to use a pair of long handled needle nose pliers to squeeze the green tabs at the base of the connector( don’t squeeze so hard that you break the tabs). Then you push down on the connector towards the fuel pump assembly and then pull the connector from the fuel pump assembly. Came right off the first try. Hope this helps.
The repair manual states,”do not use tools.” I couldn’t press the tabs with my finger because there isn’t enough room for my fat fingers so I had to use a pair of medical forceps to squeeze those green tabs and I slowly managed to remove without damaging anything.
I'm having an issue with my 2007 420 Rancher fuel injected 200 orig miles where it cranks but wont turn over. Fuel pump sounds like it working, makes that buzzing sound when i turn key on. By any chance is this similar to the issue you were having? I will happily compensate you for your time if you advise remedies the problem
Yea, I’m not 100% sure what your issue is on that. When I had a similar issue I replaced the fuel pump relay 38580-HP5-601 But also make sure there is no dust or moisture in any of the connections first
Got a problem with my 2015 420 maybe someone here can help. Accidentally got about 2 or 3 oz of water into the fuel tank ,didn't notice it till it stopped running. Drained the fuel,cleaned the tank.replaced the injector,i broke it, changed the throttle position censor, changed the fuel lines,snapped off the injector body inside the line. replaced the in tank fuel filter and pump. It'll idle but boggs down when i give it a slight push on the throttle. Running straight gas no ethanol. HELP!!
Why did your pour the dirty petrol from the pump reservoir back into the tank? Tip it into an old saucepan and use it to clean things with. Next video... Think of all the tricky bits that someone will strike who have never done this, or much mechanical, before.... Make your video instructional, not just info
Very good video. Thanks for not having some annoying techno music playing in the background.
No problem!
Love the video. It might be better if you could add links to the parts you purchased to the description below the video.
Thanks for sharing,
Sincerely .................
Good job man! I like how you went back and corrected yourself, great video!
Yup, thanks for watching!
Very informative video, watched lots of others to try change my fuel pump before coming across this, the others didn’t mention the little o-ring at the top of the fuel pump I ended up having to take bike to shop that was the problem wished I had watched this video. Can I make a suggestion you put in a tutorial about getting that little green clip off on the outlet hose, I struggled for ages trying to work that out... otherwise great video
Yea I’m not too sure what the best way to do that without breaking anything is
hi, how do u disconnect the HP fuel line from plastic?
Ya I need that info too, I'm trying to fix my quad right now
Nip together the green clip with one pair of thin long nose pliers, then gently use a second pair to remove it that line.
Could you show me how to replace the fuel FILTER? I’m just learning and your videos are great.
It would be nice if you showed actually taking it out and disconnecting fuel lines
Good job on the video, it was very helpful.
Glad it helped!
How did you get the pressure seal off? The long s skinny one with the rubber gasket?
Would’ve been a much better video if you would’ve showed how you remove the fuel pump and what all that entails for people that don’t know how like me. Thank you for your videos can you help would be appreciated. Thank you.
is their a special tool for removing the hose with a clip holding it on
I was able to use a pair of long handled needle nose pliers to squeeze the green tabs at the base of the connector( don’t squeeze so hard that you break the tabs). Then you push down on the connector towards the fuel pump assembly and then pull the connector from the fuel pump assembly. Came right off the first try. Hope this helps.
The repair manual states,”do not use tools.” I couldn’t press the tabs with my finger because there isn’t enough room for my fat fingers so I had to use a pair of medical forceps to squeeze those green tabs and I slowly managed to remove without damaging anything.
Great video and thanks! What were the symptoms before swapping fuel filter? And how did you determine it was your fuel filter please? Thanks again!
first is never run ethanol fuel ever
what is the trick to disconnect the HP fuel line from the housing?
Idk I’m trying tn
How did you know the pump was gone, inside your gas tank was it bubbling and not running well?
Sorry I haven’t seen this! I put a multi meter on the pin slots and it was getting power, but the pump made no noise or vibration like it was working
Thanks
Hiw did you get the green and blue hose off?
Wdym green and blue hose?
Great video happy I ain’t got to do this shit.
How do you loosen the hose with green tab
Honestly I’m not sure what the best way to do that is. Always had trouble with that, sorry
Needle nose pliers...slow wiggle.
@@tf7274 do u squeeze the green clip below the black clip, or push in the green inside the rectangular hole? its eating my lunch here,, mannnnn
@@mudgrippmike3489 Mine came out with a squeeze on the clamp and a wiggle. Dont break the clip.
@@mudgrippmike3489 below the tabs using a pair of medical forceps.
thanks good tips
Dang Buddy! What had you using for fuel, Tar??? Lol
I'm having an issue with my 2007 420 Rancher fuel injected 200 orig miles where it cranks but wont turn over. Fuel pump sounds like it working, makes that buzzing sound when i turn key on. By any chance is this similar to the issue you were having? I will happily compensate you for your time if you advise remedies the problem
Yea, I’m not 100% sure what your issue is on that. When I had a similar issue I replaced the fuel pump relay 38580-HP5-601 But also make sure there is no dust or moisture in any of the connections first
Got a problem with my 2015 420 maybe someone here can help. Accidentally got about 2 or 3 oz of water into the fuel tank ,didn't notice it till it stopped running. Drained the fuel,cleaned the tank.replaced the injector,i broke it, changed the throttle position censor, changed the fuel lines,snapped off the injector body inside the line. replaced the in tank fuel filter and pump. It'll idle but boggs down when i give it a slight push on the throttle. Running straight gas no ethanol. HELP!!
Maybe the air fuel sensor on the throttle body, sorry I haven’t had this problem
@@Adam-uy9zb had someone with more information than me. He said he's pretty sure it's the ECU. Got it ordered now to wait until I install it......
@@johnbeckham51 Did this work? I am having the same problem right now whenever I give mine gas it wants to die on me
@@brockruenger7543 the problem was , after$400 in shop fees, a bad sparkplug. Change that first . Hope that's the problem
@@johnbeckham51 ooof man that was the first thing I did... didn't do me any good unfortunately.
Fix the hols on your seet
Okay....
Why did your pour the dirty petrol from the pump reservoir back into the tank? Tip it into an old saucepan and use it to clean things with.
Next video... Think of all the tricky bits that someone will strike who have never done this, or much mechanical, before.... Make your video instructional, not just info
Video fail.
Only reason why I came here was to see specifically how you got those lines off.