☕☕Good morning, Do cylinder sleeves remove easily and do you replace any other parts in the block during the procedure like rods & bearings? Awesome truck by the way!! +cool factor points for the reverse function!!👍👍
Good morning mate They usually do come out easy, I use a zip tie through the exhaust outlet and turn the flywheel. Usually pops them straight out Then I’ve had others that just won’t budge, use extreme heat etc and still can’t get them out. Had people put them in a vice with small bit of wood and knock them out It’s a good time to inspect everything and change as needed Everything else was good on this so it wasn’t required Traxxas 3.3 engines it’s advised to change the rod out as they tend to split Thanks I’ve been searching for one of these for a long time Tuned up nicely now after the break in and it flies. I’ll do another video with it Hoping to find a nice open dirt area to take it to
Whoot whoot for the short course
☕☕Good morning,
Do cylinder sleeves remove easily and do you replace any other parts in the block during the procedure like rods & bearings? Awesome truck by the way!!
+cool factor points for the reverse function!!👍👍
Good morning mate
They usually do come out easy, I use a zip tie through the exhaust outlet and turn the flywheel. Usually pops them straight out
Then I’ve had others that just won’t budge, use extreme heat etc and still can’t get them out.
Had people put them in a vice with small bit of wood and knock them out
It’s a good time to inspect everything and change as needed
Everything else was good on this so it wasn’t required
Traxxas 3.3 engines it’s advised to change the rod out as they tend to split
Thanks I’ve been searching for one of these for a long time
Tuned up nicely now after the break in and it flies. I’ll do another video with it
Hoping to find a nice open dirt area to take it to
Is it OK to add your channel to my list on the nitro rc life page on Facebook
Hi. Yes of course, that will be fine thank you