@@noprosrc Bought one at a yard sale and had to install a pull start it was terrible stripped screws and grease covered areas I had to watch the video to figure out where the screws are
@@noprosrc The last thing I'd do is take it to my hobby shop. They are friendly and knowledgeable but they charge a LOT for repairs. I like to repair them but if the hex heads are stripped I get SCREWED! Hahaha? Why nobody laugh?
Learning to fix my RC by just DIY!
You didn’t show how to disconnect the throttle 😮
That’s a No Pro mistake. My bad.
The par in middel is the shifter and that is the part that makes the wheele to turn
Almost at 1k 👍🏾
Working hard for it bro!
You wouldn't realize how hard it is to remove these with stripped screws. It is the worst thing that could ever happen.
Oh wow, I couldn't imagine that. 😤
@@noprosrc Bought one at a yard sale and had to install a pull start it was terrible stripped screws and grease covered areas I had to watch the video to figure out where the screws are
@@rctrucks2094 The good thing is that you get the experience by DIY and saving money.
@@noprosrc The last thing I'd do is take it to my hobby shop. They are friendly and knowledgeable but they charge a LOT for repairs. I like to repair them but if the hex heads are stripped I get SCREWED! Hahaha? Why nobody laugh?
@@rctrucks2094 😂
I can’t get the bell gear out even after taking the clips off :-(
Have you tried using the clutch bell/flywheel tool?
There’s only 4 bolts holding the motor in, all you gotta do is loosen those …. Then it pops right out ….
Trans