Branch Reinforcing Pad Calculation | ASME B31.3 | Example | Piping Mantra |

[@ansarbaig7183]

I am piping Designer and I worked in JGC Japan. I enjoy watching your video as these are interesting and similar to my interest.

[@sambitp634]

Your valuable information is helping me a lot.Thanks a ton

[@vivekpatel1483]

Madam, your video is very good

[@ahmedanwar4586]

Good explanation thanks for your efforts

[@adnannasirvlogs7241]

Very well explained, please make video on impact testing

[@pankajkumar-hr5ok]

Good explanation.
I am so think that if A1 is more than (A2 +A3) then branch reinforcement is required otherwise not. Because A4 is adding to make A1

[@paritoshpratap87]

Informative for non designers...

[@Suriyapandi.Pitchaimuthu]

Thanks for good information

[@AHMEDALI-rq7jg]

very helpful video, than you

[@RijuA1984]

Pump head and pump calculation expected next .thank you

[@qurankatarjuma397]

Dear mam, please make a video regarding Impact test requirements per ASME B31.3

[@RijuA1984]

Great

[@KarTiratna]

Pl note that the value of L4 selected in Area A3 calculation (example) must be lesser value from 62.5 & 52.5mm whereas 62.5 is selected in calculating A3. It seems to be corrected.

[@joissreenivas]

In order to calculate A3, two values of L4 of 62.5mm & 52.5mm are calculated and lesser of the two values(52.5mm) is to be used and same is said in explaining but in the example shown 62.5mm is used which is wrong.

[@paurushshetty468]

Exactly

[@bijubhaskar2407]

Lesser value should be considered.. In this case 52.5 mm

[@lotustweeys]

Padding is required in support?

[@MerajKhan-dn8xo]

Total area of reinforcements is greater hence Rf pad is not required please clarify based on ur video u said while explaining only formula

[@purttisoumyamohanta3507]

Yes is reinforcement pad is required or not please clarify

[@PipingMantra]

Not required

[@umeshbalsaraf6549]

Is it same for pressure vessel ?

[@lojalearnsoftwares]

i would like to know as well....

[@YogeshKumar-hu7dh]

Can you share calculations pdf ?

[@bijubhaskar2407]

d2=(Tb-c)+(Th-c)+(d1/2)....its not (Th+c) as mentioned in the video.... Please refer the code